What did you do to your C4 today?
#3541
Intermediate
#3542
Racer
We used to powder coat the rotors, and the put them on the machine and cut just where the pads made contact.
They stayed pretty nice for a while.... but that was on street rods that don"t see the abuse and heat a sports car puts on them.
They stayed pretty nice for a while.... but that was on street rods that don"t see the abuse and heat a sports car puts on them.
#3543
Safety Car
Thread Starter
Originally Posted by cvsisinthehouse
Anyone else paint their rotors? I replaced the sawblade wheels with C6 ones which exposed a big rusty rotor.
#3544
Race Director
Member Since: Feb 2002
Location: Compound in the Grove, Ga.
Posts: 11,325
Received 910 Likes
on
583 Posts
2020 C3 of the Year Finalist - Unmodified
2019 C4 of Year Finalist (performance mods)
2018 C4 of Year Finalist
2015 C4 of the Year Finalist
St. Jude Donor '16
2020 C3 of the Year Finalist - Unmodified
Always.
Last edited by FASTAZU; 03-20-2018 at 09:45 PM.
#3545
Le Mans Master
I rolled it forward in the garage so I could open the tool box and get the tools I need for the 383 build/motor mounts on my truck/brakes on moms truck/interior on the sierra... (383 is going in another vehicle, not the vette. Probably will be faster too...)
#3547
Racer
Cruising in NE
50 degrees in Omaha, Have to take a drive with the top down!
#3550
#3552
Instructor
Installed front and back blackout kit today
Turned out great...always wanted a vette with blackouts
Turned out great...always wanted a vette with blackouts
#3554
Melting Slicks
I can only imagine how much more those fees are due to Moonbeams socialistic policies! There is no train, just a funnel to support illegals so the libtards can hold onto power. How's that "New California" movement going? I hope it gets legs and splits the state up.
#3557
Drifting
Installed a new LS7 clutch setup (new flywheel, disc, pressure plate, hydraulic throwout bearing), torqued everything to spec, installed the bellhousing and then successfully stabbed the TKO600 back in with minimal cussing and effort. Hopefully I will have her all put back together by Sunday night and start breaking in the clutch. After the clutch I plan on buying some mandrel bends and getting a 3" x-pipe exhaust done and then take her to go get tuned.
#3559
Drifting
#3560
Safety Car
Thread Starter
Originally Posted by Krusty84
I feel for you guys up there sometimes... and then I see what your weather is like in July-August and I am like... F you guys.