Just fried the transmission
#41
Drifting
Thread Starter
I need my cup holder
I'm anxious to get the car back on the road!!!!
Last edited by 85 Stalker; 09-10-2017 at 10:04 AM.
#42
Tech Contributor
Swung by B3R earlier, the Stage III replacement trans is on its way back to them. Should be there today/tomorrow I hope.
FYI -- The convertor is a 12" 2,300/2,600 stall with anti-ballooning plates (had to double check the paperwork). It was sent out for a teardown, they went through it and it looked good. I'm running the large Dehrale with a fan cooler in the right rear quarter, so those large -AN lines will be drained too.
Hope to get the car back next week
FYI -- The convertor is a 12" 2,300/2,600 stall with anti-ballooning plates (had to double check the paperwork). It was sent out for a teardown, they went through it and it looked good. I'm running the large Dehrale with a fan cooler in the right rear quarter, so those large -AN lines will be drained too.
Hope to get the car back next week
Have a Derale Plate/Fin with the fan
#43
Drifting
Thread Starter
FYI -- I was initially worried that the quarter would get too hot -- that is not the case. The quarter has little to no heat at all.
#44
Tech Contributor
I'm either shoving my trans cooler in there, or the Water/Meth kit. Only thing I'm concerned with is getting the pump wet in that area.
#45
Drifting
Thread Starter
B3R is still working on the trim plate/indicator with the new shifter. I took a look Saturday, and the work looks amazing.
I was so excited to see the work that I forgot to take any pictures.....
I was so excited to see the work that I forgot to take any pictures.....