wiring harness connectors needed
#1
Advanced
Thread Starter
Member Since: Aug 2012
Location: Hermiston Oregon
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
wiring harness connectors needed
86 TPI car
I am looking for a couple connectors off the harness. When I took it apart, they crumbled.
Is there a vendor with pig tail for the AIC and the temp sensor in the plenum?
I looked online with some of the vendors and it was a no go.
I am looking for a couple connectors off the harness. When I took it apart, they crumbled.
Is there a vendor with pig tail for the AIC and the temp sensor in the plenum?
I looked online with some of the vendors and it was a no go.
#2
http://tpiparts.net/82_92_camaro_wiring?b=1
or http://www.eficonnection.com/eficonn...ngineType.aspx
Click on TPI in the drop down box
or http://www.eficonnection.com/eficonn...ngineType.aspx
Click on TPI in the drop down box
#4
#5
I use a good bit of product from Mouser and a couple other vendors who offer similar services but for the typical DIY'r I think EFI a very reliable source.
Last edited by WVZR-1; 03-22-2013 at 05:17 AM.
#6
Race Director
I found the best way to replace a connector is to just buy the shell and then transfer the contacts from the old connector to the new connector. You can look up the connector number in the back of the electrical section of the shop manual and then Google that number.
Some sources:
http://www.acdelcotechconnect.com/pi/wiring-connectors/
http://www.eficonnection.com/eficonnection/default.aspx
http://terminalsupplyco.com/DelphiPackard.aspx
Some sources:
http://www.acdelcotechconnect.com/pi/wiring-connectors/
http://www.eficonnection.com/eficonnection/default.aspx
http://terminalsupplyco.com/DelphiPackard.aspx