Power Effects catback off 94 ZR-1
#1
Le Mans Master
Thread Starter
Power Effects catback off 94 ZR-1
SOLD!
Catback was on the ZR-1 when I bought it in Sept. Don't know the mileage of it but the car had 24,500 on it. I need to remove and clean it up. There are no issues with it, the valve ***** work properly. Looking for $400 Local pickup or meet. Heavy exhaust would cost a lot to ship. (will fit on a any C4 if you modify the front pipes)
Catback was on the ZR-1 when I bought it in Sept. Don't know the mileage of it but the car had 24,500 on it. I need to remove and clean it up. There are no issues with it, the valve ***** work properly. Looking for $400 Local pickup or meet. Heavy exhaust would cost a lot to ship. (will fit on a any C4 if you modify the front pipes)
Last edited by RichS; 03-11-2017 at 12:47 PM.
#5
Le Mans Master
Thread Starter
I measured the GS and ZR-1 rear bumper exhaust opening and they are the same, center to center. I'm not sure how different the front pipes are between a LTx and ZR-1 since my GS has longtubes. But If someone is adapting to longtubes they would have to be cut anyway to match up to the collectors.
The following users liked this post:
SurfnSun (01-02-2017)
#7
Catback was on the ZR-1 when I bought it in Sept. Don't know the mileage of it but the car had 24,500 on it. I need to remove and clean it up. There are no issues with it, the valve ***** work properly. Looking for $450 Local pickup or meet. Heavy exhaust would cost a lot to ship.
thanks
Scott
Last edited by ScottsLS3; 01-02-2017 at 11:12 PM.
#10
I'll drop you an email later today or tomorrow. I have a PE system now with NOS PE inlet pipes for the LT5.
I have a set of LT1 PE pipes with less than 10K miles. If you sell before I contact you and the buyer has LT1/4 - I have the pipes the buyer would need.
How far is Towson MD to you?
I have a set of LT1 PE pipes with less than 10K miles. If you sell before I contact you and the buyer has LT1/4 - I have the pipes the buyer would need.
How far is Towson MD to you?