When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Thank you. I dropped my ECM onto the carpet probably 12 years ago and have no idea what I did with them. Let me know what you'd like and I'll PayPay or Venmo it over.
I found something else while pulling my interior apart yesterday I'm wondering if your 89 may have assuming its the same as 87.
This small bracket is held to the vehicle with two 10mm nuts (locations circled) and is at the bottom of the center console under where the climate control is. Pulling the center IP bezel, radio, and climate controls make it readily accessible. Mice made a nest in my '87 and rusted the heck out of the bracket and the nuts. If you have it and would part with the bracket & nuts I'd appreciate it.
One screw on each side holds the center console frame to the sides of the bracket.
I'd also be interested in the wiring harness for the radio/speakers if your 89 had the Bose system and it isn't a total pain to extract.
The first part....I'm not sure what I'm looking at there. Where is that? Behind the gauge cluster?
The console bolts, I should have those.
Speaker harnesses I'll have to look. I may not have those anymore, and if I do, they'd only be from the door post to the speaker as I chopped the harness at the post when I removed the door; there isn't a door harness connector like there is in foreign or newer domestic cars.
The first part....I'm not sure what I'm looking at there. Where is that? Behind the gauge cluster?
Where the transmission tunnel meets the center gauge cluster. It goes left/right where my finger is pointing and is held in place with two 10mm nuts which are under the climate control head if you pull it out.
The console bolts, I should have those.
I have those two thank you, it is just the bracket and 10mm nuts I'm in need of.
Speaker harnesses I'll have to look. I may not have those anymore, and if I do, they'd only be from the door post to the speaker as I chopped the harness at the post when I removed the door; there isn't a door harness connector like there is in foreign or newer domestic cars.
No worries that's ok. It was the end that goes into the radio I was interested in.
Finally gathered up those screws. This look right? The two nuts that hold down the dash bracket, 4 screws that hold the ECM to the dash brace, and the two dash to bracket bolts....
...Well, I guess I'll have to try again later. 'Vette forums can't do pics today, I guess.
Finally gathered up those screws. This look right? The two nuts that hold down the dash bracket, 4 screws that hold the ECM to the dash brace, and the two dash to bracket bolts....
...Well, I guess I'll have to try again later. 'Vette forums can't do pics today, I guess.
Doh, I'll pop you an email address via PM if it's easier.
FINALLY! Sorry that it took me so long! These look right?
Yup! Those and the metal bracket the two with the built-in washer were holding down to the bell housing area of the trans tunnel. Believe it or not someone had an '87 BOSE radio harness on eBay so I crossed that ugly item off my list.
Hey Scorp, Yep, I've got that bracket too. $20 + shipping? Does that sound alright to you for the parts and pieces?
-Tom
Absolutely. I'm going to probably start putting things back together soon so if you're able to send USPS Priority (not Priority Express) to zip code 02347 that'd be great. Just let me know the total and I'll PayPal or however you'd like it.
07-09-2018, 10:05 AM
Let me know what you'd like and I'll PayPay or Venmo it over.
