JAKE

I've got a thread running on the C4 General board - Cruise Control - trying to get help on sorting out why mine doesn't work.

Please take a look and give me any feedback on how to solve this. I don't want to duplicate it on this board.

Thanks,

Jake

93*Corvette

At least put in the link for us....
http://forums.corvetteforum.com/show....php?t=1475173

JAKE

I appreciate the advice and the assitance; should have thought of that myself.

Now, can someone please point me down the path to fix this Oh So Frustrating problem?

Jake

86PACER

Not related, but looking at your avatar, your front rims are on the wrong sides.

JAKE

"Oh, Grand Ma, what sharp little eyes you have", LOL

Those photos were taken by the previous owner when he was advertising the car for sale. I noticed it right off too and they were swapped before I took delivery.

BTW, the idiot tire changer damaged the two LTP sensors in the process, which the seller now has to replace at no cost to me.

Jake

Ruff Rider

I'll be darn, they sure are.. Hey i could use a guy like you "one that pays attention to details" need a JOB....LOL 101st Air Borne

JAKE

See, it's one of the things I do to get attention; I've got this low self-esteem thing going on. LOL

Jake

obnoxus

I know a big problem in these is the vaccum lines.

They either rub or dryrot, thats where I would start.

Skrud13

During my engine rebuild (new head gaskets, water pump, etc) I found a vacuum hose by the distro that had a tiny hole in it. Replaced it and I got the cruise to work again.......now if I could just get it to hold speed. It drops about 1 mph every 10 seconds. Any ideas??

Bad Karma

Mine doesn't work either. I found the vacuum line going to manifold was not connected, one of the T fitting melted. Somewhere behind the distibutor, so I have to dig in there and find the connection so I can fix it. Hopefully that will fix my problem.

For the dropping speed. I would check you vacuum lines, maybe there is another slow leave and you are not keeping enough vacuum to maintain speed?

HOWSER

Underneath the passenger side fuel rail cover there is a plastic "T" fitting that is prone to rot and breaking. It just needs to be replaced.

Very common on the LTx's.

Good luck.

Eric

juanway

I found this plastic Vac. valve on drivers side near distributor had deteriated it is a vac valve that gets it vac near the fuel regulator the valve cost $7 dollars at the dealer and now my cruise works great.

Wildcat1

I had to readjust the sensor under the pedal after replacing my brake booster. That may be a good place to check.