Push-ON Oil Filler Cap falls Off any ideas??
#1
Instructor
Thread Starter
Push-ON Oil Filler Cap falls Off any ideas??
Hi,
I have the proform valve covers with a 1.25 diameter oil fill opening.
I have been using the Trans-Dapt filler plug
but it has fallen off twice, and I am looking for a more positive plug arrangement.
Does anyone make a better set-up for a push-in (track worthy at 6500rpm)?
Could a machine shop cut a thread into the cover?
Any adapters available?
ANY IDEAS????
I have the proform valve covers with a 1.25 diameter oil fill opening.
I have been using the Trans-Dapt filler plug
but it has fallen off twice, and I am looking for a more positive plug arrangement.
Does anyone make a better set-up for a push-in (track worthy at 6500rpm)?
Could a machine shop cut a thread into the cover?
Any adapters available?
ANY IDEAS????