A guestion for the A/C wiring experts...
#1
Le Mans Master
Thread Starter
A guestion for the A/C wiring experts...
I just removed my whole a/c system and installed an (a/c delete pully kit) from TPIS..On first startup my fan came on and stayed on constantly.. I figured one of the plugs I disconnected was causing the fan to run, so I plugged them all in and unplugged them one at a time..I found that the small 2 prong switch ( Im guessing its a switch) when plugged back in made the fan stop running and act normal again..For now I unscrewed the switch from the tube,plugged it in and am letting it just hang there...My question is, what do I do to the wires so I can remove the switch and not have the fans run?..Do I just cut the wires and connect them together?..Thanks in advance....WW
#2
Le Mans Master
It's a normally closed switch so you simply connect the 2 wires to keep the circuit grounded and that will keep the a/c fan signal (an open circuit when the switch opens at about 230 psi) from reaching the ECM.
#3
Le Mans Master
Thread Starter
SunCr , I should have known you would answer about a/c, your probably the most knowledgeable person on the CF when it comes to all aspects of the systems...Thanks for helping me out...Again.....WW
Last edited by WW7; 05-22-2013 at 08:29 PM.