Rear hatch hinge to body mounting gasket.
#1
Race Director
Thread Starter
Rear hatch hinge to body mounting gasket.
I have lost the gaskets for the rear hatch and I looked up art number and gm wants like 25 bucks each for them.
So anyone ever make some before? Or have any idea what would make a good gasket to replicate these.
Im thinking they were pretty thin rubbery material.
Maybe a bike tire tube would work.
So anyone ever make some before? Or have any idea what would make a good gasket to replicate these.
Im thinking they were pretty thin rubbery material.
Maybe a bike tire tube would work.
Last edited by phrogs; 03-03-2022 at 06:53 PM.
#2
Zen Vet Master Level VII
Me? I'd get a small sheet of black dense foam rubber (with sticky on one side) and cut the pattern to fit. The sticky will hold it in place.
#3
Race Director
Thread Starter
Yeah but I don't want it too thick. It was really thin, just a barrier I thought about foam but feel its a bit thick. It might work not sure yet.
Last edited by phrogs; 12-07-2017 at 07:37 PM.