Reserve Why - Page 2 - CorvetteForum - Chevrolet Corvette Forum Discussion

Notices
C4 Tech/Performance L98 Corvette and LT1 Corvette Technical Info, Internal Engine, External Engine

Reserve Why

Old 08-14-2018, 05:56 PM
  #21  
aklim
CF Senior Member
 
aklim's Avatar
 
Member Since: Jul 2004
Location: Hartford WI
Posts: 14,787
Thanked 713 Times in 699 Posts
Default

Originally Posted by fake View Post
I am looking at C4 vettes that are showing reserve on there fuel gauge. Why would you scvange off the bottom of the tank all the crud? When i see cars like that on line i just delete them, it just shows lack of care or no knowlege of how they are affecting mechanical operation of car
Show me your knowledge of gravity. Does it flow upwards or downwards? Fuel does NOT go to the top of the tank for the pump to pickup. Pickup is at the BOTTOM which is where the crud is. Assuming there is any crud.

Originally Posted by fake View Post
Why suck the sock or what ever so it loads up with debrie I guess the crap flows on top and when you run on low fuel this does not get sucked in to your fuel filter and than to your injectors or carb.
The sock is always going to be having suction from the pump. There is a filter on all 3 parts. The tank, after the pump and in the fuel injector. Bigger issue will be the varnish build up in the fuel path INSIDE the injector.
aklim is offline  
Old 08-14-2018, 06:38 PM
  #22  
confab
CF Senior Member
 
confab's Avatar
 
Member Since: Nov 2013
Location: Greater Cincinnati Area.
Posts: 2,746
Thanked 259 Times in 230 Posts
Default

At this point our cars are so old, I don't know that it matters? My car is 33 years old. It was completely unsurprising to find a small amount of debris in the bottom of the tank when I changed the pump.

I just mopped it out. It's fine.
confab is offline  
Old 08-14-2018, 08:24 PM
  #23  
GUSTO14
CF Senior Member
 
GUSTO14's Avatar
 
Member Since: Sep 2003
Location: eastern NC
Posts: 6,743
Thanked 669 Times in 605 Posts
Default

Originally Posted by fake View Post
Why suck the sock or what ever so it loads up with debrie I guess the crap flows on top and when you run on low fuel this does not get sucked in to your fuel filter and than to your injectors or carb.
Frank, don't forget the rather large, high pressure fuel filter on the chassis before it gets to the fuel rail. If that thing is changed on schedule, getting debris in your injectors should not be much of a concern.

On a side note, I was forced to store my '85 when it was only 6 years old, for a 3-year overseas tour. I had planned for my Dad to start it and run the engine from time-to-time so I left fuel in the tank. Of course he never bothered to start the car and one thing led to another so it ended up stored inside my car trailer for 9 years. When I finally did remove it from storage it needed a new battery and fuel pump, and to rebuild the clutch slave. Changing out the fuel pump was almost the easiest task and while the pump was rusted, the tank was spotless. After removing the old fuel and changing the few items, the car started and performed flawlessly. Over all, it seems like a pretty robust fuel system.

Good luck... GUSTO

Last edited by GUSTO14; 08-14-2018 at 08:25 PM. Reason: syntax
GUSTO14 is online now  
Old 08-15-2018, 12:16 PM
  #24  
DGXR
CF Senior Member
 
DGXR's Avatar
 
Member Since: May 2013
Location: Sacramento California
Posts: 1,843
Thanked 146 Times in 138 Posts
Default

Originally Posted by GUSTO14 View Post
Frank, don't forget the rather large, high pressure fuel filter on the chassis before it gets to the fuel rail. If that thing is changed on schedule, getting debris in your injectors should not be much of a concern.
What exactly is the schedule for fuel filter replacement? I have scoured the owner's manual and found lots of info on the oil filter, air filter and automatic transmission filter, but not a single word about this chassis-mounted fuel filter. I know exactly where it is on the car, and I actually have a new one to be installed in the near future. I just want to know about the service schedule. Thanks
DGXR is offline  
Old 08-15-2018, 12:22 PM
  #25  
LT4Runner
Junior Member
 
LT4Runner's Avatar
 
Member Since: May 2017
Location: Lakeland Florida
Posts: 15
Thanked 1 Time in 1 Post
Default

I spoke with the car lot owner about this when I picked up my 96. According to him they keep the fuel level low so that if/when the gas goes a bit stale after sitting, all they have to do is add a few gallons of fresh and then the car is good to go.
LT4Runner is offline  
Old 08-15-2018, 08:43 PM
  #26  
GUSTO14
CF Senior Member
 
GUSTO14's Avatar
 
Member Since: Sep 2003
Location: eastern NC
Posts: 6,743
Thanked 669 Times in 605 Posts
Default

Originally Posted by DGXR View Post
What exactly is the schedule for fuel filter replacement? I have scoured the owner's manual and found lots of info on the oil filter, air filter and automatic transmission filter, but not a single word about this chassis-mounted fuel filter. I know exactly where it is on the car, and I actually have a new one to be installed in the near future. I just want to know about the service schedule. Thanks
If I'm driving my car much, I like to change it annually or at 10k miles. Filters aren't expensive and injectors are, so I may be overdoing it.

I found these procedures on another Forum and I think they pretty much cover it...

1. Do this when the engine is stone cold!
2. Remove gas cap to relieve pressure.
3. A "crows foot" socket on the end of a 3/8" drive 12" extension will work wonders.
4. Loosen the small screw holding the filter bracket. Do NOT remove. Just loosen the screw enough, so the filter can rotate inside the bracket.
5. After disconnecting the rear fitting, use a socket on the end of the filter to help remove it.
6. Be prepared for a gasoline shower.
7. Make sure the o-rings on the fuel lines are in place and in good shape before installing new filter. Lube both o-rings to facilitate installation.
8. Tighten everything so no fuel leaks.
9. Remember to tighten your gas cap!
10. Start engine and check for leaks.


I would just add one more thing, and that is before loosening any of the fittings around the filter, release the fuel pressure on the fuel rail at the Shrader valve where you normally would attach a fuel pressure gauge to check line pressure.

Good luck... GUSTO

Last edited by GUSTO14; 08-15-2018 at 08:43 PM.
GUSTO14 is online now  
Old 08-15-2018, 10:27 PM
  #27  
PatternDayTrader
CF Senior Member
 
PatternDayTrader's Avatar
 
Member Since: Oct 2008
Location: Lansing MI and Houston TX
Posts: 6,064
Thanked 589 Times in 471 Posts
Default

Originally Posted by DGXR View Post
What exactly is the schedule for fuel filter replacement? I have scoured the owner's manual and found lots of info on the oil filter, air filter and automatic transmission filter, but not a single word about this chassis-mounted fuel filter. I know exactly where it is on the car, and I actually have a new one to be installed in the near future. I just want to know about the service schedule. Thanks
Every 30k is typical.
PatternDayTrader is online now  
Old 08-15-2018, 10:29 PM
  #28  
PatternDayTrader
CF Senior Member
 
PatternDayTrader's Avatar
 
Member Since: Oct 2008
Location: Lansing MI and Houston TX
Posts: 6,064
Thanked 589 Times in 471 Posts
Default

Originally Posted by confab View Post
At this point our cars are so old, I don't know that it matters? My car is 33 years old. It was completely unsurprising to find a small amount of debris in the bottom of the tank when I changed the pump.

I just mopped it out. It's fine.
This. ^^
PatternDayTrader is online now  
Old 08-15-2018, 11:12 PM
  #29  
aklim
CF Senior Member
 
aklim's Avatar
 
Member Since: Jul 2004
Location: Hartford WI
Posts: 14,787
Thanked 713 Times in 699 Posts
Default

Originally Posted by GUSTO14 View Post
If I'm driving my car much, I like to change it annually or at 10k miles. Filters aren't expensive and injectors are, so I may be overdoing it.

I found these procedures on another Forum and I think they pretty much cover it...

1. Do this when the engine is stone cold!
2. Remove gas cap to relieve pressure.
3. A "crows foot" socket on the end of a 3/8" drive 12" extension will work wonders.
4. Loosen the small screw holding the filter bracket. Do NOT remove. Just loosen the screw enough, so the filter can rotate inside the bracket.
5. After disconnecting the rear fitting, use a socket on the end of the filter to help remove it.
6. Be prepared for a gasoline shower.
7. Make sure the o-rings on the fuel lines are in place and in good shape before installing new filter. Lube both o-rings to facilitate installation.
8. Tighten everything so no fuel leaks.
9. Remember to tighten your gas cap!
10. Start engine and check for leaks.


I would just add one more thing, and that is before loosening any of the fittings around the filter, release the fuel pressure on the fuel rail at the Shrader valve where you normally would attach a fuel pressure gauge to check line pressure.

Good luck... GUSTO
I'd do it in a well ventilated space and no open flame. Let it air before starting anything.
aklim is offline  
Old 08-15-2018, 11:26 PM
  #30  
marksp
CF Member
 
Member Since: Sep 2006
Location: Henryville Indiana
Posts: 87
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Originally Posted by Tom400CFI View Post
LOL is right. This, folks, is "Worryin' about **** that ain't worth worryin' about".
WOW.......There should be an IQ test before posting in the tech section
marksp is offline  
Old 08-15-2018, 11:32 PM
  #31  
PatternDayTrader
CF Senior Member
 
PatternDayTrader's Avatar
 
Member Since: Oct 2008
Location: Lansing MI and Houston TX
Posts: 6,064
Thanked 589 Times in 471 Posts
Default

Originally Posted by marksp View Post
WOW.......There should be an IQ test before posting in the tech section
Who is it that you might think will fail ?
PatternDayTrader is online now  
Old 08-15-2018, 11:59 PM
  #32  
marksp
CF Member
 
Member Since: Sep 2006
Location: Henryville Indiana
Posts: 87
Thanks: 0
Thanked 0 Times in 0 Posts
Default

The original post.
marksp is offline  
Old 08-16-2018, 10:00 AM
  #33  
Tom400CFI
CF Senior Member
 
Tom400CFI's Avatar
 
Member Since: Aug 2004
Location: Park City Utah
Posts: 13,528
Thanked 563 Times in 502 Posts
Default

Originally Posted by marksp View Post
WOW.......There should be an IQ test before posting in the tech section
Originally Posted by PatternDayTrader View Post
Who is it that you might think will fail ?
X2. :
Tom400CFI is offline  
Old 08-16-2018, 08:07 PM
  #34  
marksp
CF Member
 
Member Since: Sep 2006
Location: Henryville Indiana
Posts: 87
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Originally Posted by Tom400CFI View Post
X2. :
Sorry guys I wasnt referring to either of you. I was commenting on the original poster. I thought what Tom said was hilarious. I guess I'm the idiot now

Last edited by marksp; 08-16-2018 at 08:30 PM.
marksp is offline  
Old 08-16-2018, 09:24 PM
  #35  
PatternDayTrader
CF Senior Member
 
PatternDayTrader's Avatar
 
Member Since: Oct 2008
Location: Lansing MI and Houston TX
Posts: 6,064
Thanked 589 Times in 471 Posts
Default

Originally Posted by marksp View Post
Sorry guys I wasnt referring to either of you. I was commenting on the original poster. I thought what Tom said was hilarious. I guess I'm the idiot now
Go vote for the c4 as Corvette of the year and all will be forgiven.
Heres a link.

https://www.corvetteforum.com/forums...or-2019-a.html
PatternDayTrader is online now  
Old 08-16-2018, 11:19 PM
  #36  
marksp
CF Member
 
Member Since: Sep 2006
Location: Henryville Indiana
Posts: 87
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Originally Posted by PatternDayTrader View Post
Go vote for the c4 as Corvette of the year and all will be forgiven.
Heres a link.

https://www.corvetteforum.com/forums...or-2019-a.html
marksp is offline  


Thread Tools
Search this Thread
Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2018 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: