FS: 2000 Nassau Blue FRC
10-19-2015, 07:56 PM
#1
Instructor
Thread Starter
Member Since: Apr 2000
Location: San Diego County CA
Posts: 160
Received 0 Likes
on
0 Posts
FS: 2000 Nassau Blue FRC
Excellent condition inside and out, 48000 miles, original and very responsible owner, non-smoker, purchased off the dealer showroom floor (wasn’t outside), no accidents, no tickets, garaged throughout it’s life, never winter driven, and in San Diego for past 10 years. It runs perfectly, and paint is excellent and original. Fully equipped with heads-up display, active handling, factory Y2K polished aluminum wheels, dual zone air, etc. Stock with minor bolt-on improvements: Blackwing air filter, B&M ripper shifter, A&A framesaver rails, column lock bypass, throttle body bypass, LED lighting kits - interior and exterior (except headlights and taillights), C5 flasher fix with variable turn signal flashing speed (an add-on plug-in wiring harness), headlight motor brass gear replacements (both motors), blue+black Wet Okole seat covers (leather is excellent underneath). Stereo mini-disc player and all speakers upgraded with Infinity Kappa Series. Used as the good weather 2nd car, and traction control left on 100% of the time. Tires: Sumitomo HTRZ-II non-runflats, stock sizes. Full maintenance history available.
Entering my 60s - time to pass this beauty on to an equally enthusiastic owner. $16,500. Here are a couple of pix to get started:
Update 10/20/15 - new photo - the factory delivery/options sheet. GM's polished aluminum wheel supplier had problems delivering for a period of time, so, I had to swap them in a year or two after getting the car - it's not showing on the sheet.
Entering my 60s - time to pass this beauty on to an equally enthusiastic owner. $16,500. Here are a couple of pix to get started:
Update 10/20/15 - new photo - the factory delivery/options sheet. GM's polished aluminum wheel supplier had problems delivering for a period of time, so, I had to swap them in a year or two after getting the car - it's not showing on the sheet.
Last edited by 00FRCBlue; 10-20-2015 at 10:01 PM. Reason: Added photo of GM delivery/options sheet.
The following users liked this post:
00FRCBlue (10-20-2015)
The following users liked this post:
00FRCBlue (10-20-2015)
The following users liked this post:
00FRCBlue (10-21-2015)
10-21-2015, 03:59 PM
#6
Instructor
Thread Starter
Member Since: Apr 2000
Location: San Diego County CA
Posts: 160
Received 0 Likes
on
0 Posts
The following users liked this post:
00FRCBlue (10-21-2015)
10-21-2015, 09:59 PM
#9
Instructor
Thread Starter
Member Since: Apr 2000
Location: San Diego County CA
Posts: 160
Received 0 Likes
on
0 Posts
It looks great - if you're referring to the trim around the rear window - not much that I can see - the window seal is good, no leaks (but almost never caught in the rain), however, I did not attempt to remove the black trim on the inside to see it more closely. Here are a few photos taken today, inside and outside of the window, plus a shot of the Wet Okole seat covers.
Last edited by 00FRCBlue; 10-21-2015 at 10:14 PM. Reason: Additional comments
The following users liked this post:
00FRCBlue (10-22-2015)
The following users liked this post:
00FRCBlue (10-22-2015)
11-01-2015, 11:55 PM
#12
Instructor
Thread Starter
Member Since: Apr 2000
Location: San Diego County CA
Posts: 160
Received 0 Likes
on
0 Posts
The car has been sold! The sale was finalized within a few days of my original post. (The buyer made it to the west coast to see the car this weekend.)
Thanks again to all interested corvette forum members!
Thanks again to all interested corvette forum members!
12-24-2015, 11:16 AM
#15
Melting Slicks
12-28-2015, 02:05 AM
#16
Le Mans Master
The following users liked this post:
Corvette Poor (12-28-2015)