c5 race car
#8
Car has trans and diff braces 3.90 gears solid driveshaft couplers with urethane inserts,ZR1 rear sway bar, walbro450 fuel pump with race tronix wiring harness pdaft aluminum coil overs , has drilled and slotted rotors,rear brakes mounted on front for 15 skinny front runners,also have the stock front brakes,sparco evo 2 seats with Simpson hardness,c6 zo6 shifter, wideband gauge integrated into egr for HP tuners,411pcm upgrade with SD and live tuning. the engine is 416c.i. 6.2l aluminium block with a lunati 4inch forged crank Oliver rods and racetec forged pistons total seal rings comp solid roller t&d
Shaft rockers GM hollow stem intake valves ferrea 1.65 exhaust valves PAC springs , 3/8stainless pushrods,custom ported GM casting heads,holley single plane custom ported,accel 4500 throttle body ls9 injectors,powermaster mini alternator,kooks 2inch headers ,custom 3.5 exhaust , quarter master optimum v 7.25 triple disk clutch with quarter master tri lite throw out bearing. Has a set of 17x10front and 17x11 rear ccw wheels also have some weld alumastar 15 inch front runners . Has a lexan rear window.also have all the factory parts that came off car like hood deck lid wheels A/C etc... car has only made one pass from a dig went 10.66 @136 leaving from idle and short shifting with a half *** tune because my USB cable was acting up I have time slip and data log of pass that pass was on motor car has nitrous system just need to get a 4500 plate from when I switched from a 4150 flange to a 4500
Car made 640 on tires on race gas with 27 degrees of timing. made 606 on pump gas and 23degress of timing that was before I put bigger throttle body ,headers,exh,and intake have not been to dyno since
should make right at 700rwhp on race gas and tailpipes removed
Shaft rockers GM hollow stem intake valves ferrea 1.65 exhaust valves PAC springs , 3/8stainless pushrods,custom ported GM casting heads,holley single plane custom ported,accel 4500 throttle body ls9 injectors,powermaster mini alternator,kooks 2inch headers ,custom 3.5 exhaust , quarter master optimum v 7.25 triple disk clutch with quarter master tri lite throw out bearing. Has a set of 17x10front and 17x11 rear ccw wheels also have some weld alumastar 15 inch front runners . Has a lexan rear window.also have all the factory parts that came off car like hood deck lid wheels A/C etc... car has only made one pass from a dig went 10.66 @136 leaving from idle and short shifting with a half *** tune because my USB cable was acting up I have time slip and data log of pass that pass was on motor car has nitrous system just need to get a 4500 plate from when I switched from a 4150 flange to a 4500
Car made 640 on tires on race gas with 27 degrees of timing. made 606 on pump gas and 23degress of timing that was before I put bigger throttle body ,headers,exh,and intake have not been to dyno since
should make right at 700rwhp on race gas and tailpipes removed
Last edited by wes427; 08-05-2016 at 11:12 AM.
The following users liked this post:
wes427 (08-28-2016)