C5 Forced Induction/Nitrous C5 Corvette Turbochargers, Superchargers, Centrifugal, Twin Screw & Roots Blowers, Twin Turbo Kits, Intercoolers, Wet & Dry Nitrous Injection, Meth
Sponsored by:
Sponsored by:

150 Shot on top of H/C?

Thread Tools
 
Search this Thread
 
Old 10-10-2002, 12:13 PM
  #21  
Austrian Vette
Safety Car
Support Corvetteforum!
 
Austrian Vette's Avatar
 
Member Since: Feb 2000
Location: Austria
Posts: 3,683
Likes: 0
Received 0 Likes on 0 Posts

Default Re: 150 Shot on top of H/C? (Tuan Le)

Michael,

You're still using the nozzles, right? Same here, but instead of using two NX Shark nozzles, I got a new NX SX2 nozzle. I might get another SX2 nozzle for the second stage.

It's so funny when you ask around and everyone swears up and down that you definitely need to go to direct port for more than 150shot. But I doubt that most of these guys ever been to 150 yet.:lol: :lol: :lol: I guess we'll find out what's the limit on these nozzles.:cheers:

Tuan,

For now my Nitrous system is not installed.
I tune the car for a last NA run in cool weather.
IŽve installed a new cam from a friend (streetable but rough :D) and
set the shiftpoints to 6600.
IŽll try to gain about 2 tenths and run a 10,7NA.

But I need to have all Nitrous parts deinstalled or noone here would trust me that I didnŽt use it.

After that IŽll start to set up for a special 400+ 3 stage direct port for my new engine that I hope to be able to do during winter.

I have done up to 200 shot with the Nozzles, worked great.
I would not do more because of fuel puddling.
And I donŽt like the possibillity of backfiring.....
........so for the real big shot thereŽs again a direct port going in.

Michael
Old 10-10-2002, 12:15 PM
  #22  
Austrian Vette
Safety Car
Support Corvetteforum!
 
Austrian Vette's Avatar
 
Member Since: Feb 2000
Location: Austria
Posts: 3,683
Likes: 0
Received 0 Likes on 0 Posts

Default Re: 150 Shot on top of H/C? (LuvmyC5)

I'd worry more about the trans holding up to it, than the bottom end. There are plenty of cars in the forum that put out some serious hp/torque, that still use the stock bottom end.
IŽm sure the stock bottom end would let off bevore my FLP.
I swear on that tranny.
It did have to take a lot of power this season and
didnŽt let me down a single time!!

FLP Level IV is :smash:

Michael


[Modified by Austrian Vette, 5:16 PM 10/10/2002]
Old 10-10-2002, 12:58 PM
  #23  
0Sales@MVPAutoParts.com
Former Vendor
 
Sales@MVPAutoParts.com's Avatar
 
Member Since: Nov 2000
Location: Houston TX
Posts: 5,607
Likes: 0
Received 0 Likes on 0 Posts
Default Re: 150 Shot on top of H/C? (Austrian Vette)

After that IŽll start to set up for a special 400+ 3 stage direct port for my new engine that I hope to be able to do during winter.
400shot, that is more than what most of C5's around here put out on motor. :lol: :lol: :lol:
Old 10-10-2002, 01:14 PM
  #24  
Austrian Vette
Safety Car
Support Corvetteforum!
 
Austrian Vette's Avatar
 
Member Since: Feb 2000
Location: Austria
Posts: 3,683
Likes: 0
Received 0 Likes on 0 Posts

Default Re: 150 Shot on top of H/C? (Tuan Le)

After that IŽll start to set up for a special 400+ 3 stage direct port for my new engine that I hope to be able to do during winter.400shot, that is more than what most of C5's around here put out on motor. :lol: :lol: :lol:
And I expect a good ET with that setup, then :yesnod:
Old 10-18-2002, 09:34 PM
  #25  
bruce1
Melting Slicks
 
bruce1's Avatar
 
Member Since: Mar 2001
Location: Oceanside, Ca. Ca.
Posts: 2,866
Likes: 0
Received 0 Likes on 0 Posts

Default Re: 150 Shot on top of H/C? (O-Ace)

Will the stock bottom-end hold up to 570 RWHP and 600+ RWTQ?

Thanks.
For a while!



Quick Reply: 150 Shot on top of H/C?



All times are GMT -4. The time now is 02:33 AM.