1999 FRC Pro Mod Style TT Kit
#261
Melting Slicks
Thread Starter
Haha, it was no small feat. 6 or 7pm till 2am every night for about 10 days. It needs some tuning and other things to make it driveable but I'm excited to hear it run for the 1st time.
#262
Melting Slicks
not that I can see, my guess is the pin was pushed a towards the front of the car a little. and fluid is now seeping from around the outside of the bolt, im guessing its some sort of press seal
#263
Melting Slicks
Thread Starter
Keep us posted on how things turn out. I don't have any drive time yet so I'm not sure on what the results will be.
#264
Melting Slicks
Thread Starter
Here are some views of the completed turbo kit. I still need to do some tuning to make it drive able and then begin fitting the rest of the body panels.
The following 5 users liked this post by Turbo-Geist:
C5 Pete (05-06-2019),
FourG63 97GST (05-06-2019),
Mickman (05-06-2019),
nfantbabyjesus (05-13-2020),
Turpid porpoise (05-07-2019)
#266
Melting Slicks
Thread Starter
#267
Melting Slicks
Thread Starter
A little more progress was made this weekend. It felt really good to make a trip around the block.
The following 3 users liked this post by Turbo-Geist:
The following 5 users liked this post by Turbo-Geist:
C5 Pete (04-29-2020),
Fastbird (05-02-2020),
FourG63 97GST (05-02-2020),
InfiniteReality (05-04-2020),
niterydr (05-07-2020)
#274
Melting Slicks
Whats left to do?
#278
Melting Slicks
Thread Starter
Thanks, how is yours doing?
Radioflyer V1.0
Looking forward to doing more driving.
Thanks, I still need to check yours out in person.
Radioflyer V1.0
Looking forward to doing more driving.
Thanks, I still need to check yours out in person.
#279
Melting Slicks
Thread Starter
1. Engine needs more break-in miles and an oil change
2. Mount solenoids for CO2, plumb CO2 to gates, electrical power to solenoids
3. Install meth pump, power to meth pump and controller, route lines to meth nozzles
4. Dyno tuning
5. Install body panels and enjoy until the next round of mods
2. Mount solenoids for CO2, plumb CO2 to gates, electrical power to solenoids
3. Install meth pump, power to meth pump and controller, route lines to meth nozzles
4. Dyno tuning
5. Install body panels and enjoy until the next round of mods
The following users liked this post:
Turpid porpoise (05-04-2020)
The following 2 users liked this post by Turbo-Geist:
InfiniteReality (05-11-2020),
niterydr (05-11-2020)