Sun Guns! Low-profile HID Projectors from JWM/mtndv8 installed
#61
Team Owner
Thread Starter
I'm leaving for SoCal this afternoon so I'll be signing off temporarily until I'm set up there tomorrow.
#62
Drifting
Hi There,
Great job on the Sun Guns installation.They are really nice looking Patches. Good luck on your westward move. Sounds like your moving to a nice friendly place.BTW: Thanks for the info. furnished about the Black wing.Its on there & with the quad cruiser its running good. Should have installed a t/plate before hand.Your c/cans are they the ones from eliteengineering or CCA ? Thats next on my list.
Thanks for any info. provided.
robsc501
Great job on the Sun Guns installation.They are really nice looking Patches. Good luck on your westward move. Sounds like your moving to a nice friendly place.BTW: Thanks for the info. furnished about the Black wing.Its on there & with the quad cruiser its running good. Should have installed a t/plate before hand.Your c/cans are they the ones from eliteengineering or CCA ? Thats next on my list.
Thanks for any info. provided.
robsc501
#63
Drifting
#68
Melting Slicks
Very nice! I would defnately want something like this when I can ever get around to it!
P.S. Good luck with the move!
P.S. Good luck with the move!
Last edited by JimZRyd; 07-25-2010 at 10:21 PM. Reason: added message
#69
Fantastic! How bad was the install and did you replace the headlight gear at the same time?
Oh, and for those who do have to drive their cars in the rain, how protected is everything?
Nice to see that C5 HID projectors didn't end with the death of the Light Cannons. Clean cutoff is exactly what the doctor ordered.
Oh, and for those who do have to drive their cars in the rain, how protected is everything?
Nice to see that C5 HID projectors didn't end with the death of the Light Cannons. Clean cutoff is exactly what the doctor ordered.
#71
Burning Brakes
whatever happened with these? Are they still being made. These are fairly simple, just hella projectors which can be purchased and nicely cut aluminum pieces. Not very fancy but very cool none the less.
#72
Team Owner
Thread Starter
Holy resurrected thread, Batman!
FYI, a LOT of design and prototyping went into these assemblies to ensure they fit and work properly. This was done by Michael (forum member mtndv8) back when no one else was attempting a factory-quality low-rise design and he put up his own scratch to make it happen. You really need to see these up close and personal to appreciate the difficulty of the integration into the stock system and the quality of the components and system as a whole.
Mods, lock this one down, please, so it dies a quiet death.
FYI, a LOT of design and prototyping went into these assemblies to ensure they fit and work properly. This was done by Michael (forum member mtndv8) back when no one else was attempting a factory-quality low-rise design and he put up his own scratch to make it happen. You really need to see these up close and personal to appreciate the difficulty of the integration into the stock system and the quality of the components and system as a whole.
Mods, lock this one down, please, so it dies a quiet death.
Last edited by Patches; 07-05-2017 at 09:22 AM.
The following users liked this post:
mtndv8 (07-06-2017)
bulbs, c5, ca, corvette, gun, guns, headlamps, headlights, hid, jwm, lowprofile, projectors, sun, sunguns, temecula