Tightening the visor
06-12-2011, 06:23 AM
#2
Race Director
Member Since: Oct 2004
Location: Home of the VOLS ! Knoxville, TN. Tennessee
Posts: 12,906
Received 774 Likes
on
435 Posts
St. Jude Donor '11-'12-'13, '15, '16-'17-'18-'19
The lock tabs may be broken.
There is a flat screwdriver slot in the plastic piece attached to the visor.
Insert visor into trim piece, insert screwdriver in slot and turn with visor while holding the screwdriver to lock visor in place.
You will hear it lock in place.
If it is still falling ,then you have to replace the visor, if both trim pieces are falling, then you may just need a new locking trim piece.
Hope that makes sense.
There is a flat screwdriver slot in the plastic piece attached to the visor.
Insert visor into trim piece, insert screwdriver in slot and turn with visor while holding the screwdriver to lock visor in place.
You will hear it lock in place.
If it is still falling ,then you have to replace the visor, if both trim pieces are falling, then you may just need a new locking trim piece.
Hope that makes sense.
