[Z06] What did you do to your Z06 TODAY??
#4462
Supporting Vendor
I had the braided hose running under the red covers over to the drivers valve cover but the vacuum pump pulled to much oil into the catch can for that location.
Running it to the oil filler cap gets it up away from the splashing oil and now it barely pulls any oil. I left the hose long until I find the best location. Still testing.
Thank you,
Christian
__________________
Don't forget to check out our products at www.saccitycorvette.com
If you like our products, tell others! If not, tell us!
Don't forget to check out our products at www.saccitycorvette.com
If you like our products, tell others! If not, tell us!
#4463
Banned Scam/Spammer
Member Since: Sep 2016
Location: Philadelphia PA (Birthplace of the USA, UNESCO World Heritage City)
Posts: 4,004
Received 3,916 Likes
on
1,616 Posts
#4464
Le Mans Master
Member Since: Jan 2000
Location: Georgetown TX
Posts: 8,431
Received 1,867 Likes
on
1,083 Posts
C5 of Year Finalist (appearance mods) 2019
The following users liked this post:
Maxx_Z06 (02-10-2019)
#4465
Supporting Vendor
The foam was in the box used to protect a big TV I purchased. Logging the air intake temp with HPTuners the foam lowered the intake temp around 20 degrees. It is a 440ci big cam and runs hot in the summer, so 20 degrees made a big difference.
I actuall have some of the same foam in black that I will switch out. I dont think it did anything for areo.
Thank you
Christian
#4467
Le Mans Master
The following 4 users liked this post by Maxx_Z06:
#4469
I bought it!
May the project commence
The following users liked this post:
ArmchairArchitect (02-12-2019)
#4470
Race Director
Member Since: Dec 2010
Location: Atlanta, GA
Posts: 10,426
Received 1,261 Likes
on
1,056 Posts
2020 Corvette of the Year Finalist (performance mods)
C5 of Year Winner (performance mods) 2019
The following users liked this post:
FYRARMS (02-10-2019)
#4474
Added some engine bling.
#4475
Safety Car
Member Since: Jul 2012
Location: Houston Texas
Posts: 4,543
Received 277 Likes
on
85 Posts
C5 COTM Coordinator
Finally FINALLY wrapped up my aftermarket seat build/install and about about 80% of the interior upgrades I started last fall. At least its drive-able again after 6 months .
The following users liked this post:
BABYBUGY (05-02-2019)
#4477
Put the hydro carbon fiber dipped brake ducts on. The local painter did a mediocre job but I put them on the car anyway. Also finished up the engine bay and the front end. Scraped the the new front splitter a couple times but so far it has survived, not going to lower the car at all. Added a small spoiler on the back too.
#4478
Removed that god awful BSM. Well, I'm around 10% done. The other 90% is removing the adhesive
The following 2 users liked this post by Maxx_Z06:
BABYBUGY (05-02-2019),
Millenium Z06 (09-07-2019)