Black Friday Sale New Sun Visors!
#1
Supporting Vendor
Thread Starter
Member Since: May 2010
Location: Bell Buckle, TN
Posts: 6,811
Received 232 Likes
on
134 Posts
St. Jude Donor '11
Black Friday Sale New Sun Visors!
Say Goodbye to Floppy Ears!
We now have these in stock for your C5. They are new reproduction and are a direct replacement for your visors. They come ready to install! They also come with new air bag warning stickers.
We are in the process of getting the Anniversary Shale visors into production. We will have them in the future.
These are a great option for the tired C5 Visors.
Backed by a 1year warranty.
Retail $150 a pair plus shipping
Black Friday Sale pricing $120 a pair plus shipping!
Sale is good until Monday 11/28/11 at midnight!
Here is a link to order: http://www.vettenuts.net/index.php?l...t_detail&p=319
Here are the instructions from the GM service manual:
Sunshade Replacement
Removal Procedure
1.Tilt the sunshade down toward the windshield.
2.Insert a flat head screwdriver blade into the slot in the sunshade inner bezel.
3.Using the screwdriver against the elbow of the sunshade arm for leverage pull down on the sunshade arm while rotating the sunshade outboard until the sunshade stops. (the first tab disengages).
4.Push up on the sunshade and continue rotating the sunshade outboard until the sunshade with the inner bezel disengages from the mounting bezel.
5.Disconnect the electrical connector.
6.Remove the sunshade.
7.Disassemble as necessary.
If removing the mounting bezel, pull the bezel from the garnish molding with your fingers.
If replacing the inner bezel, remove the bezel from the sunshade shaft and press the new bezel onto the shaft.
Installation Procedure
1.Route the harness through the mounting bezel.
2.Insert the mounting bezel into the garnish molding engaging the snap fingers.
3.Connect the harness to the sunshade electrical connector.
4.Push the connector up through the bezel and through the hole in the garnish molding.
5.Position the sunshade approximately midway between the windshield and the side of the vehicle.
6.Insert the rod with inner bezel firmly attached fully into the mounting bezel.
7.Rotate the sunshade toward the center line of the vehicle until the sunshade locks in place.
Last edited by Marc@Vettenuts.net; 11-28-2011 at 11:41 AM.
#3
Supporting Vendor
Thread Starter
Member Since: May 2010
Location: Bell Buckle, TN
Posts: 6,811
Received 232 Likes
on
134 Posts
St. Jude Donor '11
We should have them in the distant future, my manufacturer is going to make them the next time he sets up to run another production of the black ones. Im unsure of the time frame. Wish i could be more help.
Marc
Marc