[Z06] How to remove clutch line (pic) and gasket
#1
Drifting
Thread Starter
How to remove clutch line (pic) and gasket
How do you disconnect this?
What is the gasket that goes here so I can replace this. Looks like it has a leak but not enough to make a drop.
What is the gasket that goes here so I can replace this. Looks like it has a leak but not enough to make a drop.
#2
Le Mans Master
Member Since: May 2007
Location: Belleville Mich.
Posts: 5,393
Likes: 0
Received 15 Likes
on
14 Posts
In regards to that leak at the junction of the tailshaft & main part of transmission.
That had black sealant applied at the factory, & was never a gasket in stalled there.
After a while that sealant deteriorates & forms a red trans oil leak.
That had black sealant applied at the factory, & was never a gasket in stalled there.
After a while that sealant deteriorates & forms a red trans oil leak.
#4
Melting Slicks
If you have it down I would just take care of it now. Otherwise it will bother you that you didn't :P On my old C5 I was able to separate it only about an inch(bolts still holding it together), clean it up and put a good layer of high temp RTV in there. Never leaked again.