Leds bulbs in window switch c5
#1
Advanced
Thread Starter
Member Since: Feb 2008
Location: CALUMET CITY IL
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
Leds bulbs in window switch c5
I PURCHASED LED BULBS FOR MY WINDOW SWITCH, AND THE BULBS ARE A LITTLE BIGGER BUT THE INSTRUCTIONS SAY PUSH IN THE BULBS FIRST THEN TWIST TO LOCK. THE STOCK BULBS ARE SLIMMER . IS THEIR IN EASIER WAY WITH OUT BREAKING THE BULBS
#2
Race Director
The ones I got from JWMotoring fit perfectly, but I remember in a recent thread someone talking about using a dremel tool to trim theirs down a bit. Good luck.
#3
Supporting Vendor
The 10mm bulbs are somewhat of a pain to install. We use 8mm base bulbs in our conversion kit which are MUCH easier to install (especially if you need to remove them because you got the polarity backwards) and fit all locations including the HUD and dimmer switch.
http://shop.radioflyerinnovations.co...ersion-051.htm
http://shop.radioflyerinnovations.co...ersion-051.htm
The following users liked this post:
J. Kent (08-04-2018)