Toque

Guys:

Anyone have a PCB board schematic on the Radio ?

I'm working on an LED mod of my radio. Instead of soldering resistors on each LED I was wanting to find a single point on the radio PCB board to connect a single resistor. This would enable me to install LED's directly to the board and not have to solder resistors on each LED. I need a schematic so I can be sure that where I tie in the resistor there are no "OTHER" components down stream that need 12v.

Thanks !
Toque

SilverC54me

See my reply in the "new led mod" thread on the radio lighting.

Gary