AnteVenom

I am changing over to Halltech Tric on Tuesday at same time of TPIS Header and Cartek Clutch install.

I will have the RM Twin Flow Air Intake, K&N Filter Oiling Kit, Powerduct from WCC and Red Silicone Coupler.

Package price $250 or separately as listed below:

Twin Flow and Oiling Kit $180
Powerduct and Coupler $130

Additional **note**

Powerduct currnetly has recalibrated/relocated MAT sensor. Relocated to front right from left rear. Thsi means two holes in duct. currently one is plugged by stock MAT nd the other has MAT mod.

his may be an issue for some buyers but is easily worked out for those still interested.

Please post or email me if you have interest.

ThanksChuck Schramm - 1999 Coupe - Black on Black 6 Speed, Twin Flow Intake, Cold Screens Max Flow Mass Air Flow Sensor, Recalibrated/Relocated MAT Sensor, Power Duct with C5 Emblem, Halltech Ported Throttle Body, Bassani Quiet Thunder Exhaust/X-Pipe, Hypertech Programmer III, Painted Gill Inserts, Mirrored Chrome Exhaust Plate, Billet Chrome Taillight Set, Billet Chrome License Plate Frame, LS1 Plate for top of Throttle Body, Intake Manifold Cover by C5reations, LLoyd Floor Mats, CAGS Defeat, Painted Hood Liner,Carbon Fiber Shift ****, Aluminum Gas and Dead Pedals, Z06 Chrome Reproduction Wheels, Goodyear F1 P265 ZR40/17 Front, Goodyear F1 P295 ZR35/18 Rear Zaino all over

:cheers:


[Modified by chucschramm, 8:35 PM 8/10/2001]

Theblkraven

How many miles are on the intake and coupler?

AnteVenom

The air intake and powerduct have been on since January 2001 and have about 6000 miles on them. The coupler is newer (March 2000 when I got a red one) it has nearly 3000 miles.

Thanks for your interest!

Chuck

AnteVenom

I have come up with a picture of the setup for those that might be interested.

Chuck

Theblkraven

How would you suggest plugging the hole in the power duct so it doesnt look bad??

AnteVenom

Sale Pending!!

AnteVenom

You could plug the hole several ways depending on your requirements.

If you used a relocated/recalibrated MAT you would have my setup. I am not sure if you are saying you think the setup in the picture looks bad but it was ok for me.

You could also use another rubber grommet and plug it with a small piece of rubber hose.

I am sure there are many other ideas out in the forum as this could not be the first time this application would be undertaken.

Thanks for your interest.

Chuck

:chevy

Theblkraven

Chuck,
Did not mean to imply the pic of your setup looked bad. Wrong choice of words. I was just meaning that if the second hole was plugged with something it might look very obvious unless as you suggested, just use another grommet, and everything would look ok.