jak112460

I never used these covers and kept them in the box. They are polished and in new condition. Comes with bolts. Will sell for $200.00 shipped anywhere to the lower 48 states. Jeff 480-747-7739


http://i3.photobucket.com/albums/y82...01109Small.jpg

jak112460

bump

0Mike Yeager@Eastcoast Performance

Need some better pics please, of both covers, who makes them and what heads do they fit? thanks

jak112460

I would prefer not to unwrap the other cover and risk scratching it. I don't know who the manufatcturer is. I'm not sure what you are asking about what heads they fit. I know they will fit LS1/LS6 heads as I said in my post. If it means the difference between selling them or not I will unwrap both covers.

0331MARINE

I'm with Mike I would like to see both if you could. Thanks

jak112460

Ok Here you go.

http://i3.photobucket.com/albums/y82...01110Small.jpg

Chrisbequick

I could be wrong, but I'm fairly certain those are SBC centerbolt covers.

-Chris

WKMCD

! Not LS VC's.

SteveDoten

no doubt, the part # on the side of the box tells the story(I would assume )

jak112460

No part number on box. After comparing them to my stock covers I have laying around in the garage they are definately small block covers. I never even opened them until I put them here for sale. I need to know what years had center bolt covers like that? Would C4 section be the place to sell them? Thanks. Here is a picture from the bottom.


http://i3.photobucket.com/albums/y82...01111Small.jpg

hotwheels57

Those are for the LT1/LT4 generation motors (Corvette, Impala SS, Camaro, etc).

They'd also fit the ZZx series of GMPP crate motors (ZZZ, ZZ3, ZZ4)...

Pewter1

My 1998 LS1 has center bolt hole heads.......so these will fit some early LS1's

Tech

All C5 Corvettes came with center bolt valve covers. Unfortunately, these bolt holes aren't the same as the LSx series head. They look like LT1 valve covers based upon size/shape.

Y2Kvert4me

Not quite.

97/98 C5s that came with 806 heads were perimeter bolt.

Pewter1

I was wrong......my 98 has the perimiter valve cover holes............problem is now I have TFS heads with center bolts......I need a new set of valve covers......too bad these won't work! Mine have to be tall enough to fit the YT Roller rockers.....Nasty Performance I guess is one of my options......Good luck on your sale, and thanks for helping get me educated! Can you send me pictures of the bottom of these?
Thanks in advance Jeff!

Pewter1

Sorry Jeff, ended up buying some from Nasty Perf, here locally, I needed the bung welded on for the coil packs.....not something you want to do to unknown brand covers.....thanks for the pictures though, and good luck on the sale.

jak112460

I remote mounted my coil packs.

Pewter1

I did think of that too, but decided to go this way instead, they also guarantee them not to warp! Some guys end up doing this one twice.....after they start leaking.

ChopperLoco

Also they are not very likley billet,I'd say cast.