fast 90mm intake ported (needs repair)
#1
Melting Slicks
Thread Starter
fast 90mm intake ported (needs repair)
SOLD
hey guys
this intake was a 92mm but i bought a use 90mm to replace it and was able to put the 92mm upper on the 90mm lower the only difference is the throttle body opening size between the two. not to get confused this is now a 90mm fast intake
the intake has a crack in the bottom its about 3.5" long, i tried to fix it a couple of times but failed not sure what i did wrong? I've seen a lot of post of guys being able to fix much worst cracks and never have a problem after? other then the crack its fine but it does need the rope seal when i did the swap it didnt look so good and just threw it out ($25 to replace) simple to install other gaskets are included
this intake was ported by some hot shot viper specialist (Greg Good)
to be legal i'll say $100,000 really just looking for an offer?
i'm in the chicago area in case your local, if not will ship
again this is a 90mm ported fast with one crack about 3.5" long in the bottom, if your handy and can repair plastic this is for you
i removed the stuff i used for the repair since it didnt still, i drilled the ends of the crack to stop it from getting bigger it work
hey guys
this intake was a 92mm but i bought a use 90mm to replace it and was able to put the 92mm upper on the 90mm lower the only difference is the throttle body opening size between the two. not to get confused this is now a 90mm fast intake
the intake has a crack in the bottom its about 3.5" long, i tried to fix it a couple of times but failed not sure what i did wrong? I've seen a lot of post of guys being able to fix much worst cracks and never have a problem after? other then the crack its fine but it does need the rope seal when i did the swap it didnt look so good and just threw it out ($25 to replace) simple to install other gaskets are included
this intake was ported by some hot shot viper specialist (Greg Good)
to be legal i'll say $100,000 really just looking for an offer?
i'm in the chicago area in case your local, if not will ship
again this is a 90mm ported fast with one crack about 3.5" long in the bottom, if your handy and can repair plastic this is for you
i removed the stuff i used for the repair since it didnt still, i drilled the ends of the crack to stop it from getting bigger it work
Last edited by Stroker87; 03-08-2016 at 11:30 AM.
#3
Melting Slicks
Thread Starter
pics updated
i removed the stuff i used do you can see the crack, worst case replace the bottom fast told me $300 today for a know one
i removed the stuff i used do you can see the crack, worst case replace the bottom fast told me $300 today for a know one
#4
Melting Slicks
Thread Starter
bump!
here a link to a member that had a worst crack and was able to repair it, i think i just used the wrong JB weld product when i tried to fix it
https://www.corvetteforum.com/forums...old-crack.html
here a link to a member that had a worst crack and was able to repair it, i think i just used the wrong JB weld product when i tried to fix it
https://www.corvetteforum.com/forums...old-crack.html