FS: Performance Lower Shifter Boxes
#141
Supporting Vendor
Thread Starter
Shifter Movement
These shifters are as mechanical and smooth feeling and slop free as possible.
Some of the first shifters coming of the milling machine and ready for assembly.
Some of the first shifters coming of the milling machine and ready for assembly.
Last edited by TMODcustoms; 09-26-2018 at 01:48 AM.
#147
Supporting Vendor
Thread Starter
5% reduction (left) 20% reduction (right)
Notice the difference? The bottom of the 5%er is elongated towards the bottom, this allows the bearing (pivot point) to sit closer to the tip of the shaft. If you look at the bottom of a factory shifter it does the same thing, it's below the top of the shifter box.
#149
Supporting Vendor
Thread Starter
Place your orders while you still save ten bucks on the combo!
__________________
TMODCUSTOMS Specialty CNC Products
C5, C6 & C7
Performance Shifter Boxes
Upgraded Shifter Options
Zero-Slop Shifter Linkages
Don't replace your clutch without upgrading your linkage!
www.TMODCUSTOMS.com
info@tmodcustoms.com
TMODCUSTOMS Specialty CNC Products
C5, C6 & C7
Performance Shifter Boxes
Upgraded Shifter Options
Zero-Slop Shifter Linkages
Don't replace your clutch without upgrading your linkage!
www.TMODCUSTOMS.com
info@tmodcustoms.com
#150
Melting Slicks
Order in, but while I patiently wait my turn I'm hoping to hear some reviews of the ****. I have complete faith in the shifter design and obviously the lower box, but that **** is significantly different than anything in my past.
#151
Le Mans Master
Member Since: Jul 2011
Location: Morristown New Jersey
Posts: 7,263
Received 914 Likes
on
721 Posts
Oldtimer
REDZ, if you are referring to the bar type shifter shown above, FWIW, that kind of shifter dominates race cars, in particular rallye cars. It’s a slightly different hand hold, but it does provide a variety of grips and increased leverage if desired.
#152
Supporting Vendor
Thread Starter
Thanks bud! If you dont like it you can go with lots of other stuff, its the most common thread size 9/16-18. And if you want I'll make you a shorter one and you can try that or as well.
#155
Supporting Vendor
Thread Starter
Another super satisfied lower box customer here! I cut down the stock shifter about 1.12" and threaded for a Hurst ball. The little chevy shifts as smooth as silk now!!!
And Tom is a great guy to work with!
If you ANY thoughts about doing the lower box at least DO IT …..NOW!!! :-)
And Tom is a great guy to work with!
If you ANY thoughts about doing the lower box at least DO IT …..NOW!!! :-)
The following users liked this post:
TMODcustoms (10-17-2018)
#158
Heel & Toe
As long as my car survives this upcoming track day, I will probably be ordering a shifter from you. Looks to be a good improvement from stock. Interesting design for sure!
The following users liked this post:
TMODcustoms (10-17-2018)
The following users liked this post:
TMODcustoms (10-17-2018)