Maximum depth you can fly cut ??? Crap !!!
#1
Burning Brakes
Thread Starter
Member Since: Jul 2006
Location: felton de
Posts: 764
Likes: 0
Received 0 Likes
on
0 Posts
Maximum depth you can fly cut ??? Crap !!!
Anybody know the maximum depth you can fly cut a stock piston. I have heard .120 but I cut one to .164. Not planning on nitrous ....so am I safe or shall I worry from now on out Crap!!!! Thanks
Last edited by brian vette; 11-15-2007 at 10:04 PM.
#2
Melting Slicks
Brain,
Here is the thread where it was mentioned that LG recommended a max cut of .080".
http://forums.corvetteforum.com/show...hlight=fly+cut
If you don't get any other replys here, try the LS1Tech forum.
Here is the thread where it was mentioned that LG recommended a max cut of .080".
http://forums.corvetteforum.com/show...hlight=fly+cut
If you don't get any other replys here, try the LS1Tech forum.
#3
Race Director
Member Since: Oct 2002
Location: Gone
Posts: 16,477
Likes: 0
Received 18 Likes
on
15 Posts
CI 6-7-8-9-10 Veteran
St. Jude Donor '03
I've seen preople cut up to about .140" deep successfully.
There is about 1/4" (.250) meat on the piston top. You might be ok, just make damn sure you never run lean!
And serious, it's time to put the drill down and use something a little slower, ie: tap wrench or air ratchet. (those notching tools were actually designed to be used by hand).
There is about 1/4" (.250) meat on the piston top. You might be ok, just make damn sure you never run lean!
And serious, it's time to put the drill down and use something a little slower, ie: tap wrench or air ratchet. (those notching tools were actually designed to be used by hand).
#4
Burning Brakes
Thread Starter
Member Since: Jul 2006
Location: felton de
Posts: 764
Likes: 0
Received 0 Likes
on
0 Posts
Fly Cutting
Okay Guys this is what I found out. The actual piston thickness is.360. and one guy actually measured it to be 8 mm. The cut I made is .164 the rest .120 intake, that gave me clearance of .085. Exhaust .125 for a clearance of .100 So maybe it will be alright. Great tip about running lean . Start up in 2 days so then we will see Thanks