American Hydrocarbon

I bought a front plate off the auction, sent it out and had it finished in Navy Carbon Fiber to match my engine bay and interior. Then I sent it to "Quick Z06" to have the screen mod done. Quick Z06 did a great job on the plate and at a very reasonable cost. I did not want to cut out the large area that most people remove from the fascia so I decided to experiment with a 2" hole saw first, I could always cut out the plate area if I did not like the holes.

[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]

I like the holes.
[IMG][/IMG]
[IMG][/IMG]

American Hydrocarbon

I might paint the inside area flat black and the holes will dissappear?

Bounty

Looks great...

Oh, and yeah, I too would paint the interior of the plate flat black to camouflage the holes and give a "deeper" appearance.

DocHorton

Looks Sweet, I kind of like the holes!

VIPERBLUELX

what's the point in this mod except for looks? That air never reaches the radiator does it?

Padrino

Great job.

Who's "Quick Z06" where you had the screen mod done?? Do you have a contact for them. What did that little piece set you back??

Padrino

hattitude

No..... It directs cold air to the airbox.....

VIPERBLUELX

Ahh so if you've done the Callaway Honker or flip-tie mod it won't help?

American Hydrocarbon

"Quick Z06" is a supporting vendor. $59.00 shipped. You supply the plate.

mrm1149

That looks great and has to help air flow. Just plain mean looking

DevilMan02

They're not just holes...they're SPEED holes.

American Hydrocarbon

Three holes - good for 3hp at least?