HELP!Can't figure out how/where this goes...
#1
Drifting
Thread Starter
HELP!Can't figure out how/where this goes...
Okay,i'm rebuilding an 01 Z theft recovery car.Attempting to install the rear fascia/bumper cover.This part came with the rear fascia.It does not fit on the outside of the bumper cover,although in the GM parts book AND service manual it looks like it does!It may fit some where inbetween the cover and the body but i cannot figure this out
Keep in mind i did not take this apart!
Thanks-Dominic
Keep in mind i did not take this apart!
Thanks-Dominic
#3
Drifting
Thread Starter
Thanks...
...I'm starting to think the part i have is not even a vette part but looks similar to the euro plate frame in the GM parts book .I'll go to the dealer tomorrow to check.
Dominic
Dominic
#4
Safety Car