Seat control module question
03-22-2018, 11:55 PM
#1
Instructor
Thread Starter
Seat control module question
I think I already know the answer, but I want to consult the brain trust here on the forum. My driver's seat will only move forward and back and was also inflating and deflating the sides with out the switch being actuated. I think my module has gone belly up. But need a second opinion. Thanks.
03-23-2018, 02:47 AM
#2
Safety Car
It sounds to me like a switch problem as they are known to fail. I cannot say for sure without more information though.
The seat module would likely throw codes. In case you haven't already seen this here is a video on how to retrieve codes from the DIC. If you have any codes please post them.
The seat module would likely throw codes. In case you haven't already seen this here is a video on how to retrieve codes from the DIC. If you have any codes please post them.
Last edited by Rob 02; 03-23-2018 at 02:48 AM.
The following users liked this post:
granpastoy (03-31-2018)
The following users liked this post:
granpastoy (03-31-2018)
03-23-2018, 11:21 AM
#4
Administrator
Member Since: Mar 2001
Location: In a parallel universe. Currently own 2014 Stingray Coupe.
Posts: 342,579
Received 19,186 Likes
on
13,910 Posts
C7 of the Year - Modified Finalist 2021
MO Events Coordinator
St. Jude Co-Organizer
St. Jude Donor '03-'04-'05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16-'17-'18-'19-
'20-'21-'22-'23-'24
NCM Sinkhole Donor
CI 5, 8 & 11 Veteran
Moved to C5 Tech.
03-23-2018, 01:19 PM
#5
Tech Contributor
Member Since: Dec 1999
Location: Anthony TX
Posts: 32,735
Received 2,180 Likes
on
1,583 Posts
CI 6,7,8,9,11 Vet
St. Jude Donor '08
The LUMBAR issues is separate from the seat movement. The lumbar pressure switch isn't seeing the correct set pressure (due to leaks) and continues to RUN. See if you can try to LOWER the bolster set pressure to zero and see if it quits running.
I would see if the Seat Multifunction SWITCH is your issue before you go module. Are the fuses good and the resettable breakers functioning. Do you have power to the module????
LUMBAR:
SEAT MOTORS:
Hope this helps....
BC
I would see if the Seat Multifunction SWITCH is your issue before you go module. Are the fuses good and the resettable breakers functioning. Do you have power to the module????
LUMBAR:
SEAT MOTORS:
Hope this helps....
BC
The following 2 users liked this post by Bill Curlee:
granpastoy (03-31-2018),
Rob 02 (03-24-2018)
03-23-2018, 01:23 PM
#6
Tech Contributor
Member Since: Dec 1999
Location: Anthony TX
Posts: 32,735
Received 2,180 Likes
on
1,583 Posts
CI 6,7,8,9,11 Vet
St. Jude Donor '08
There is a relay panel under the seat, check the relays also.
BC
BC
The following 2 users liked this post by Bill Curlee:
granpastoy (03-31-2018),
Rob 02 (03-24-2018)
