Yet another headlight gear question
#1
Melting Slicks
Thread Starter
Yet another headlight gear question
I was able to get the three mounting nuts and bolts off but can’t seem to slide out the motor. There is a nut on the other end of the shaft that goes into the middle of the motor. Does that need to come off too? I don’t see it mentioned in other write ups but not sure how else to slide off the motor from the shaft. Thank.
#2
Melting Slicks
Thread Starter
Well, good news is that I got the motor off and the new one in. Bad news is that the up and down doesn’t travel very far as it should (very short travel) and when I turn the lights on the “repaired one” goes down and the other one goes up. 😂 I’ll try to find mistake tomorrow.
Last edited by STRMLNE; 11-15-2018 at 06:03 PM.