[Z06] Horn stuck
11-05-2011, 02:09 PM
#1
Intermediate
Thread Starter
Member Since: Oct 2011
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Horn stuck
It might be a simple fix but I'm not mechanically inclined. I have a 2004 Z06. My horn stopped working, the fuse was blown and easy to remove. When I put the new fuse in, the horn started blowing immediatley. I pulled the fuse back out and turn off the alarm system. I put the fuse back in and the horn started again. I pulled the fuse again and this time I applied pressure to horn button on the column, I could here the switch clicking so I assumed it was working. I put the fuse back in and it was fine. I then closed the hood and the horn starting blowing again. I hit the horn switch a couple times and it was fine. Do I need to replace the horn switch? Any ideas?
11-05-2011, 06:40 PM
#3
Le Mans Master
And this video gives some great pointers.
http://www.youtube.com/watch?v=9xGQWjxLZ3s
I did mine. Easy to do. I did lose my torx bit inside the steering wheel prior to its removal which was highly frustrating. Went to autozone and picked up a torx set that was self contained like a swiss army knife. Much easier that fighting with a bit.
The membrane I think is $60 from a few vendors.
Richard
http://www.youtube.com/watch?v=9xGQWjxLZ3s
I did mine. Easy to do. I did lose my torx bit inside the steering wheel prior to its removal which was highly frustrating. Went to autozone and picked up a torx set that was self contained like a swiss army knife. Much easier that fighting with a bit.
The membrane I think is $60 from a few vendors.
Richard
