Notices
C5 General General C5 Corvette and C5 Z06 Discussion not covered in Tech
Sponsored by:
Sponsored by:

[Z06] Wtb new motor

Thread Tools
 
Search this Thread
 
Old 06-28-2017, 07:22 PM
  #1  
Jacob951
Intermediate
Thread Starter
 
Jacob951's Avatar
 
Member Since: Aug 2015
Location: Bonney Lake Washington
Posts: 42
Received 2 Likes on 2 Posts
Default Wtb new motor

Ok so my 03z ls6 has a dead hole on #7 local shops say 4 to 5k to build, but no warranty. I really want to get a warranty with my motor. I have been looking around and it seems all the dealerships can sell crate motors with 2 year warrantys but they are around 7k+. I was hoping to spend less than that as I want to do the clutch and torque tube as well. Does anyone know of any good shops in WA. State that can Build a good motor with a warranty. Or a on line place I can order from? Where does everyone get their motors from. Ls6, ls3, or ls7 not to picky just a tight budget. And yes I do know about the reluctor wheels 24&58 tooth, and the linginfelter converter. I just want her to run again I miss driving her.
Old 06-28-2017, 08:54 PM
  #2  
MY03C5Z
Race Director
 
MY03C5Z's Avatar
 
Member Since: May 2004
Location: PA
Posts: 15,791
Received 195 Likes on 148 Posts

Default

If you're on a tight budget I would look for a lower mile ls6 short block or long block for sale. I would search the c5 f/s section here and check on eBay. Otherwise I'd look at used ls3's, there should be plenty available used these days since they were also used in the Camaro for 5 years plus the c6. ls2's are a good motor as well, they can probably be had at a better price than the ls3 too. I wouldn't put ls7 and 'budget' in the same sentence lol...


.

Last edited by MY03C5Z; 06-28-2017 at 08:58 PM.
The following users liked this post:
Jacob951 (06-28-2017)
Old 06-28-2017, 09:26 PM
  #3  
grantv
Le Mans Master
 
grantv's Avatar
 
Member Since: Sep 2014
Location: Kelowna BC
Posts: 5,280
Received 534 Likes on 490 Posts
Default

Same as above. If my LS6 went in the pooper, I'd look for a used low mile motor. Preferably one where the owner is upgrading so I could witness the motor is good.
The following users liked this post:
Jacob951 (06-28-2017)
Old 06-28-2017, 09:36 PM
  #4  
pewter99
Team Owner

Support Corvetteforum!
 
pewter99's Avatar
 
Member Since: Dec 1999
Location: Here
Posts: 174,233
Received 1,194 Likes on 704 Posts
Pilot of Beer Force 1
Tampa Regional Coordinator
CI 4-5-6-7-8 Veteran
Organizer St. Jude Fundraiser
I believe in the Beer Fairy


Default

I have a forged LS6 for sale...but I am in FL ...motor has less than 5K on it, was built to go with my Maggie MP112 which is also for sale just started parting the car a few weeks ago

will eventually get it all posted up for sale...not sure if shipping that far is even feasible

and of course no warranty which is something you are looking for
The following users liked this post:
Jacob951 (06-28-2017)
Old 06-28-2017, 10:01 PM
  #5  
Jacob951
Intermediate
Thread Starter
 
Jacob951's Avatar
 
Member Since: Aug 2015
Location: Bonney Lake Washington
Posts: 42
Received 2 Likes on 2 Posts
Default

Originally Posted by MY03C5Z
If you're on a tight budget I would look for a lower mile ls6 short block or long block for sale. I would search the c5 f/s section here and check on eBay. Otherwise I'd look at used ls3's, there should be plenty available used these days since they were also used in the Camaro for 5 years plus the c6. ls2's are a good motor as well, they can probably be had at a better price than the ls3 too. I wouldn't put ls7 and 'budget' in the same sentence lol...


.
I did purchase a ls3 from ebay said it had 30k on it and it was out of a corvette. When I received it I noticed some rust on the exhaust valves so I then checked the intake valves and found the same thing. when I removed the heads I found rust in 3 of the cylinders. I was able to return it but lost about $200, so om a little apprehensive about purchasing used.
The following users liked this post:
ArmchairArchitect (06-29-2017)

Get notified of new replies

To Wtb new motor




Quick Reply: [Z06] Wtb new motor



All times are GMT -4. The time now is 07:12 PM.