Mr 74

I noticed I had some codes logged in the DIC.

They are:
C1234 LR Wheel Speed Circuit Open or Shorted
C1295 Brake Lamp Switch Circuit Open

They had an H at the end of them. I cleared them and then went out for a drive. They did not return.

I did an autocross event a few months ago and it had rained pretty hard and there was a lot of water on the course. That might of had something to do with these codes...

Does anyone have any experience with them? How do I check a speed sensor circuit?

Is the Brake Lamp switch the rear brake lights or a vanity plate light? My brake lights do work.

Any help is appreciated.

Dave

WA 2 FST

Can't help you on the brake light code.

On the wheel speed sensor, I'd just check and make sure the connection is snug and no dirt/debris around it. I had my RF one get a little loose (no idea why) and I had a code thrown (including ABS, which is all related). I pulled it apart, cleaned the connector with a dry rag, reconnected it and all was good.

Mr 74

Does anyone have a picture or drawing where the speed sensor or speed sensor hub is located?

Without having one I am guessing it can be found in the shop manual?

I would like to locate it and make sure it is clean and properly seated.

Thanks

Dave