[Z06] LS6 clutch Carnage.
#21
Banned Scam/Spammer
Member Since: May 2007
Location: Machineguns, because I don’t compromise
Posts: 15,685
Received 1,319 Likes
on
788 Posts
Posting this here in case this here to possibly spark others' imaginations.
Planning to put the smaller C5 pilot bearing in, and before I install the clutch, I'll put just the torque tube in (without transmission attached) and bolt it down to the bell housing. That way I can look in from the bottom and visually inspect the input shaft to pilot bearing engagement. Once verified I can then install the clutch and everything else knowing 100% I'm good to go.
The following users liked this post:
Moto One (09-27-2017)