ZO6 caliper picture request help?
#1
Burning Brakes
Thread Starter
ZO6 caliper picture request help?
Going to pull my silver calipers off the GS tonight and send them to Mike.
My plan is to have them coated similar to the ZO6.
Can you all post some close up pictures of your ZO6 calipers so I have a reference to provide Mike with what I want?
Appreciate the help - Chris
My plan is to have them coated similar to the ZO6.
Can you all post some close up pictures of your ZO6 calipers so I have a reference to provide Mike with what I want?
Appreciate the help - Chris
#8
Moderator
Member Since: Dec 2002
Location: Lakewood Ranch, FL
Posts: 40,065
Received 3,578 Likes
on
1,619 Posts
Mike will know what the Z06 color is without a picture - this isn't his first rodeo!
#10
Burning Brakes
Thread Starter
I have high temp BBQ paint already and will be painting my rotor hats too.
#11
Tech Contributor
Contact Mike directly if you have any questions about what needs to be done by you before shipping yours to him.
#12
Burning Brakes
Thread Starter
Yep already communicating with him. You guys were a big help and he has been patient. Can't wait to get them coated and back on the car.
Actually excited I found someone that can be trusted to coat them.
Actually excited I found someone that can be trusted to coat them.
#14
Le Mans Master
#15
Team Owner
Z06 OEM calipers are Torch red. Mike knows what to use as I went through it with him a couple years ago with my swap. I thought they were victory red but he said Torch. he was correct.
excuse the dirty pics. They were just bedded in prior to pic.
excuse the dirty pics. They were just bedded in prior to pic.
Last edited by NYC6; 11-28-2011 at 02:52 PM.
#16
Burning Brakes
Thread Starter
Check his site: www.thepowdercoater.com
#17
Burning Brakes
Thread Starter
Got a headache reading the preferred jacking locations.
I have the car sitting on jackstands on the frame rail tie down points and now I am reading this isn't okay????
I don't have anything to lay across the webbed cross members.
Any input? Not putting the car on wood, don't ask, I have learned the hard way on other vehicles. Does anyone have something that can be used with a floor jack and jack stands on the center cross members? I have seen multiple posts about the Northern Tool option that is apparently no longer an option.
I have the car sitting on jackstands on the frame rail tie down points and now I am reading this isn't okay????
I don't have anything to lay across the webbed cross members.
Any input? Not putting the car on wood, don't ask, I have learned the hard way on other vehicles. Does anyone have something that can be used with a floor jack and jack stands on the center cross members? I have seen multiple posts about the Northern Tool option that is apparently no longer an option.
Last edited by Red89gt; 11-28-2011 at 08:51 PM.