Installed my new headlight lenses! Lots of before/after pics!
#25
The Consigliere
Member Since: May 2006
Location: 2023 Z06 & 2010 ZR1
Posts: 22,247
Received 5,444 Likes
on
2,270 Posts
#26
Safety Car
Thread Starter
#28
Safety Car
Thread Starter
I exceeded my bandwidth from photobucket, the pics will reappear in two days on Feb. 20th. I had to pay $25 to Rlsebring for the instructions to figure out the time and temp. There are some other tricks and tips as well.
#29
Heel & Toe
Ok and thanks, I think the temp. is about 80-90 celsius. In here Finland we can take the ligths to Sauna, finnish sauna steam is about 80-90 celsius
#31
Race Car Tech
Can't wait to see the pics
#32
Safety Car
Thanks-I have 40K on my vert. During the daylight the lenses look perfect, but when I put on the lights at night I can see imperfections from striking bugs and sand. Nice to know I can change them myself.
#33
#37
Instructor
Member Since: Jan 2012
Location: Saint Petersburg Florida
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
Whew. Finished mine today. Anyone thinking of doing this. DO NOT cheap out and not buy the new rubber gaskets. Mine were dry rotted and had lost all their elasticity. So when I took them off I ripped a few of the tabs that hold them on. Then, when I went to put them on the finished lights they her all floppy and wouldn't sit on the headlight properly, causing quite the trouble when it was time to fit the bumpers.
#38
Safety Car
Thread Starter
Whew. Finished mine today. Anyone thinking of doing this. DO NOT cheap out and not buy the new rubber gaskets. Mine were dry rotted and had lost all their elasticity. So when I took them off I ripped a few of the tabs that hold them on. Then, when I went to put them on the finished lights they her all floppy and wouldn't sit on the headlight properly, causing quite the trouble when it was time to fit the bumpers.
For anyone who wants to see the pics and doesn't want to wait till tomorrow, here they are: http://s1114.photobucket.com/albums/...20Restoration/
#39
Instructor
Member Since: Jan 2012
Location: Saint Petersburg Florida
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
Yea I hear what you're saying. My gaskets ripped in a couple areas, I cheaped out and glued them on where need be because they fit back on the new lenses perfectly and had retained their original thickness. '
For anyone who wants to see the pics and doesn't want to wait till tomorrow, here they are: http://s1114.photobucket.com/albums/...20Restoration/
For anyone who wants to see the pics and doesn't want to wait till tomorrow, here they are: http://s1114.photobucket.com/albums/...20Restoration/
That factory glue was a pita to get out of the channel. Lol.
#40
Safety Car
Thread Starter