Stock tunnel plate
12-02-2012, 10:37 PM
#1
Drifting
Thread Starter
Member Since: May 2012
Location: Southport North Carolina
Posts: 1,618
Received 100 Likes
on
50 Posts
Stock tunnel plate
Has anyone taken their stock tunnel plate and had it ceramic coated. Looking at an alternate method to control heat in the console. Alternate to going out and buying an aftermarket ceramic coated plate.
Thank you,
Thank you,
12-02-2012, 11:11 PM
#2
Burning Brakes
I bought a replacement. It was thicker and had a thermal blanket on one side. Really cut down on the heat as it advertised. (http://forums.corvetteforum.com/c5-t...been-done.html) Good info here.
12-02-2012, 11:40 PM
#3
Team Owner
I bought a replacement. It was thicker and had a thermal blanket on one side. Really cut down on the heat as it advertised. (http://forums.corvetteforum.com/c5-t...been-done.html) Good info here.
It takes some of the body flex away as well. It really cuts down on the heat. But if you're gonna put this on-might as well put headers and an x-pipe on while you're at it. 
12-03-2012, 06:12 PM
#5
Drifting
Thread Starter
Member Since: May 2012
Location: Southport North Carolina
Posts: 1,618
Received 100 Likes
on
50 Posts
Kooks 1 3/4" Long Tube Headers - 2005-2008 Chevy Corvette C6 (LS2 & LS3) + Kooks High Flow Catted X-pipe (3" Inlet, 3" Center, 2.5" Outlet) - 2005-2008 Corvette (LS2 & LS3) Coated: Calico CT-25 CoolBlack II 1700 dg
Hope I don't get Jelly of the month club...
http://www.youtube.com/watch?v=1K8-kNuDgoA
