New from RPI! ZRAL-1 Front Chin Splitter Spoiler - More Ground Clearance! Pre-Painted
#24
Drifting
#26
Platinum Supporting Vendor
Thread Starter
We currently sell more zr1 style splitters for Z06/GS, so we started with the better mover. Tough economy, a few sales and we can build tooling for base model just like we did 4 years ago with the zr1 style splitters, skirts and rear spoilers.
#27
Le Mans Master
Member Since: Aug 2009
Location: Bucks Co. / outside Philadelphia PA
Posts: 5,437
Likes: 0
Received 4 Likes
on
3 Posts
Sounds like a very good plan. I have a GS and I am always scraping. I can only imagine how often a ZR1 scrapes and their carbon fiber will not flex like the other splitters. Do you sell many as replacements for the ZR1 crowd? The cost of the carbon fiber and how close it is to the ground was a big part of why I went with a GS over a ZR1.
#30
Platinum Supporting Vendor
Thread Starter
#31
Platinum Supporting Vendor
Thread Starter
Sounds like a very good plan. I have a GS and I am always scraping. I can only imagine how often a ZR1 scrapes and their carbon fiber will not flex like the other splitters. Do you sell many as replacements for the ZR1 crowd? The cost of the carbon fiber and how close it is to the ground was a big part of why I went with a GS over a ZR1.
#32
Racer
RPI, What is the material ? I do not want to crack and chip another carbon fiber splitter. Is the material in the painted version more flexible and less apt to crack than carbon fiber? And is the flat black the same as unpainted?
#33
Drifting
I started that thread with the callaway splitter. At the time it was only available fotr callaway replacement. It should have thebumper reinforcement if you are going over 100+ I might want one if it is layered straight to match my APR stuff. 2x2 weave I believe.
When an how much in carbon, josh?
Thanks, Scott
When an how much in carbon, josh?
Thanks, Scott
#34
Platinum Supporting Vendor
Thread Starter
No, flat black has a *slight* shine to it. The unpainted, will need to be sanded and painted.
#35
Platinum Supporting Vendor
Thread Starter
I started that thread with the callaway splitter. At the time it was only available fotr callaway replacement. It should have thebumper reinforcement if you are going over 100+ I might want one if it is layered straight to match my APR stuff. 2x2 weave I believe.
When an how much in carbon, josh?
Thanks, Scott
When an how much in carbon, josh?
Thanks, Scott
The weave is the same 2x2 that the other vendor above uses. It'll match exactly. We ask for 2-3 weeks on real carbon fiber as we make them to order. On our real carbon, we do back it with a layer of fiberglass for added strength.
#40
Platinum Supporting Vendor
Thread Starter