Replacing Front Turn Signal Blinker Bulb
#2
Team Owner
Moderately, according to others here. See pages 5-45 and 5-46 of your 2005 owner's manual.
To replace a high-beam or front parking/turn signal bulb,
do the following:
1. Turn the wheel to allow access to the wheel well.
2. Access the high-beam or front parking/turn signal
bulbs by removing the access panel. To do this,
remove the three outer fasteners and flip back
the cover.
3. Remove the outer cover to expose the high-beam
headlamp bulb socket once the access cover has
been removed.
4. Remove the headlamp bulb by releasing the outer tabs from
the socket.
Remove the front parking/turn signal bulb by turning
the bulb socket counterclockwise.
6. Replace the high-beam headlamp bulb with a new
bulb and reattach to the bulb socket.
Replace the front parking/turn signal bulb by turning
the bulb socket clockwise.
7. Reverse the Steps 2 through 4 to reinstall.
do the following:
1. Turn the wheel to allow access to the wheel well.
2. Access the high-beam or front parking/turn signal
bulbs by removing the access panel. To do this,
remove the three outer fasteners and flip back
the cover.
3. Remove the outer cover to expose the high-beam
headlamp bulb socket once the access cover has
been removed.
4. Remove the headlamp bulb by releasing the outer tabs from
the socket.
Remove the front parking/turn signal bulb by turning
the bulb socket counterclockwise.
6. Replace the high-beam headlamp bulb with a new
bulb and reattach to the bulb socket.
Replace the front parking/turn signal bulb by turning
the bulb socket clockwise.
7. Reverse the Steps 2 through 4 to reinstall.
#3
Instructor
http://forums.corvetteforum.com/c6-c...ement-diy.html
there's other threads on it, just search "changing drl"
cheers
#4
Safety Car
Make sure you look at the socket when you pull the bulb out. If it is scorched looking, you may need to replace the harness. I think 05s and some 06s had this issue. I had to change my drivers' DRL harness about 3 weeks after getting my car in 09.
#5
They left out a "minor detail" which is documented on the forum link on another response.
Remove the front parking/turn signal bulb by turning
the bulb socket counterclockwise
will not occur unless you press the lock latch, which of course you can't see.
Remove the front parking/turn signal bulb by turning
the bulb socket counterclockwise
will not occur unless you press the lock latch, which of course you can't see.