Question about seat swap: - CorvetteForum - Chevrolet Corvette Forum Discussion


C6 Corvette General Discussion
General C6 Corvette Discussion not covered in Tech
Sponsored by:
Sponsored by:

Question about seat swap:

Reply
 
 
 
Thread Tools Search this Thread
Old 09-12-2017, 04:39 PM   #1
t1blackout
CF Senior Member
Thread Starter
 
Member Since: Sep 2004
Posts: 118
Thanked 1 Time in 1 Post
Default Question about seat swap:

Hey guys,

I'm thinking about putting some 2006 Z06 seats in a 2013 C6. Will they fit? If not, what would be required to make them fit?

Thanks!

Brent
t1blackout is offline   Reply With Quote
Old 09-12-2017, 04:47 PM   #2
Corvette_Ed
CF Senior Member
 
Corvette_Ed's Avatar
 
Member Since: May 2012
Location: Dallas/Ft. Worth
Posts: 10,187
Thanked 549 Times in 442 Posts
Default

They'll fit. The seat frame is exactly the same.
Corvette_Ed is offline   Reply With Quote
Old 09-13-2017, 09:15 AM   #3
CBRDude
Junior Member
 
Member Since: Jun 2017
Posts: 36
Thanks: 0
Thanked 2 Times in 2 Posts
Default

Aren't you going backwards? Personally I think the 2013 seats are nicer than the 2006 ones are. Just an opinion now not criticizing you!
CBRDude is offline   Reply With Quote
Old 09-13-2017, 02:42 PM   #4
ncvette_1FUNRIDE
Tech Contributor
Support Corvetteforum!
C6 of Month Finalist 2015
 
ncvette_1FUNRIDE's Avatar
 
Member Since: Sep 2008
Location: Greensboro NC
Posts: 10,936
Thanked 214 Times in 195 Posts
Default

Quote:
Originally Posted by CBRDude View Post
Aren't you going backwards? Personally I think the 2013 seats are nicer than the 2006 ones are. Just an opinion now not criticizing you!
ncvette_1FUNRIDE is offline   Reply With Quote
Old 09-13-2017, 03:24 PM   #5
HOXXOH
CF Senior Member
 
HOXXOH's Avatar
 
Member Since: Sep 2007
Location: Peoria/Phoenix AZ
Posts: 12,774
Thanked 601 Times in 500 Posts
Default

Quote:
Originally Posted by CBRDude View Post
Aren't you going backwards? Personally I think the 2013 seats are nicer than the 2006 ones are. Just an opinion now not criticizing you!
I suspect the OP's looking at weight differences, while appearing stock.
HOXXOH is offline   Reply With Quote
Old 09-14-2017, 12:03 AM   #6
t1blackout
CF Senior Member
Thread Starter
 
Member Since: Sep 2004
Posts: 118
Thanked 1 Time in 1 Post
Default

Quote:
Originally Posted by CBRDude View Post
Aren't you going backwards? Personally I think the 2013 seats are nicer than the 2006 ones are. Just an opinion now not criticizing you!
A friend of mine has flood damage on his 2013 and he is looking to buy stock-looking seats to replace them. I have some 2006 available so I just wanted to see if they would fit.

What is the difference that makes the 2013 seats nicer?

Thanks guys!
t1blackout is offline   Reply With Quote
Old 09-14-2017, 10:55 AM   #7
ncvette_1FUNRIDE
Tech Contributor
Support Corvetteforum!
C6 of Month Finalist 2015
 
ncvette_1FUNRIDE's Avatar
 
Member Since: Sep 2008
Location: Greensboro NC
Posts: 10,936
Thanked 214 Times in 195 Posts
Default

Quote:
Originally Posted by t1blackout View Post
A friend of mine has flood damage on his 2013 and he is looking to buy stock-looking seats to replace them. I have some 2006 available so I just wanted to see if they would fit.

What is the difference that makes the 2013 seats nicer?

Thanks guys!
I have swapped out my 2010 seat for the 2012 seats. The only real difference is the back of the seats are a little broader in the shoulder area so it feels a little better to me.

There is a little difference in the seam pattern in the seat bottoms but really no noticeable difference in the seat feel.

I went from 2LT seats to 4LT seat with an Alcantera centers so that i what makes my 2012 seats feel even better.
ncvette_1FUNRIDE is offline   Reply With Quote
Old 09-14-2017, 10:59 AM   #8
Curt D
CF Senior Member
Support Corvetteforum!
 
Curt D's Avatar
 
Member Since: May 2015
Location: Lockport IL
Posts: 707
Thanked 82 Times in 77 Posts
Default

Quote:
Originally Posted by ncvette_1FUNRIDE View Post
I have swapped out my 2010 seat for the 2012 seats. The only real difference is the back of the seats are a little broader in the shoulder area so it feels a little better to me.

There is a little difference in the seam pattern in the seat bottoms but really no noticeable difference tin the seat feel.

I went from 2LT seats to 4LT seat with an Alcantera centers so that i what makes my 2012 seats feel even better.
Do the side bolsters hold up better than pre 2012?
Curt D is offline   Reply With Quote
Old 09-14-2017, 11:44 AM   #9
FAUEE
CF Senior Member
 
FAUEE's Avatar
 
Member Since: Oct 2012
Location: Hickory NC
Posts: 3,229
Thanked 153 Times in 133 Posts
Default

Quote:
Originally Posted by Curt D View Post
Do the side bolsters hold up better than pre 2012?
No, the side bolsters are supported the same. If you push on the seat when getting out, you will eventually damage either side bolster. If you slide your legs over the lower bolsters when getting out, you will wear them out.
FAUEE is offline   Reply With Quote
Old 09-14-2017, 12:11 PM   #10
ncvette_1FUNRIDE
Tech Contributor
Support Corvetteforum!
C6 of Month Finalist 2015
 
ncvette_1FUNRIDE's Avatar
 
Member Since: Sep 2008
Location: Greensboro NC
Posts: 10,936
Thanked 214 Times in 195 Posts
Default

Quote:
Originally Posted by Curt D View Post
Do the side bolsters hold up better than pre 2012?
No, but there is an aftermarket seat upgrade for 2011 and older (somewhere here on the forum) that has a little more dense seat foam that should wear better. Also, it helps to put some ballistic nylon fabric and jute padding between the foam and seat springs.



.

Last edited by ncvette_1FUNRIDE; 09-14-2017 at 12:12 PM.
ncvette_1FUNRIDE is offline   Reply With Quote
Old 09-14-2017, 03:14 PM   #11
HOXXOH
CF Senior Member
 
HOXXOH's Avatar
 
Member Since: Sep 2007
Location: Peoria/Phoenix AZ
Posts: 12,774
Thanked 601 Times in 500 Posts
Default

Quote:
Originally Posted by ncvette_1FUNRIDE View Post
No, but there is an aftermarket seat upgrade for 2011 and older (somewhere here on the forum) that has a little more dense seat foam that should wear better. Also, it helps to put some ballistic nylon fabric and jute padding between the foam and seat springs.
.
A plastic table placemat works just as well and can slip in under the wires without removing anything.
HOXXOH is offline   Reply With Quote
The Following User Says Thank You to HOXXOH For This Useful Post:
mikeCsix (09-15-2017)
Old 09-15-2017, 10:12 AM   #12
dmk0210
CF Senior Member
 
dmk0210's Avatar
 
Member Since: Oct 2013
Posts: 828
Thanked 99 Times in 82 Posts
Default

Are Z06 seats any different from base seats (other than the stitching or logos)?
dmk0210 is offline   Reply With Quote
Old 09-15-2017, 10:48 AM   #13
cmonkey713
CF Senior Member
 
cmonkey713's Avatar
 
Member Since: Aug 2008
Location: Edmond Oklahoma
Posts: 10,571
Thanked 240 Times in 213 Posts
Default

Quote:
Originally Posted by CBRDude View Post
Aren't you going backwards? Personally I think the 2013 seats are nicer than the 2006 ones are. Just an opinion now not criticizing you!
cmonkey713 is offline   Reply With Quote
Old 09-15-2017, 11:27 AM   #14
PCMusicGuy
CF Senior Member
 
Member Since: Apr 2007
Location: Houston TX
Posts: 2,848
Thanked 33 Times in 26 Posts
Default

While the frame fits just fine, be aware that the seatbelts are different. The metal part of the clasp and the opening size in the buckle are different sizes. You will either need to swap the seatbelts too, or keep the buckles from the original seat and put them on the new one. You also need to pay attention to electrical differences, i.e. power seats vs power seats with memory. You may have to swap the electrical harnesses between seats as well, but after all is said and done they will definitely work.
PCMusicGuy is offline   Reply With Quote
Old 09-15-2017, 12:08 PM   #15
ncvette_1FUNRIDE
Tech Contributor
Support Corvetteforum!
C6 of Month Finalist 2015
 
ncvette_1FUNRIDE's Avatar
 
Member Since: Sep 2008
Location: Greensboro NC
Posts: 10,936
Thanked 214 Times in 195 Posts
Default

Quote:
Originally Posted by dmk0210 View Post
Are Z06 seats any different from base seats (other than the stitching or logos)?
Not within model years.
ncvette_1FUNRIDE is offline   Reply With Quote
The Following User Says Thank You to ncvette_1FUNRIDE For This Useful Post:
dmk0210 (09-18-2017)
Old 09-15-2017, 02:01 PM   #16
96GS#007
Tech Contributor
 
96GS#007's Avatar
 
Member Since: Apr 2000
Location: Los Angeles CA
Posts: 7,905
Thanked 139 Times in 119 Posts
Default

Do the 2006 seats have an airbag in the bolster? My 2013 2LT seats do. Don't know when that became standard or part of whatever option package, but it's something to check on.

As I recall, the 2006 Z passenger seat was manual...no power adjustments. If your friend intends to keep the power adjustability the 2013 came with, he'll either need to find a different seat rail assembly or reuse the one from his car.
96GS#007 is offline   Reply With Quote
Go Back   CorvetteForum - Chevrolet Corvette Forum Discussion >
Reload this Page
  • Question about seat swap:
  •  
     
    Reply

    Related Topics
    Thread Thread Starter Forum Replies Last Post
    Installed Procar Rally seats DWD66VETTE C1 & C2 Corvettes 28 02-27-2017 10:39 AM
    New seat foam fitting problems? chasboy C5 General 6 12-14-2016 05:50 PM
    Anyone with Lancer Evolution seats? scubastevedds C6 Tech/Performance 2 08-22-2016 04:44 PM
    what seats fit? zigvs C3 General 15 08-11-2016 10:28 PM
    Racetech RT4009HR schaibaa C7 Z06 Discussion 4 03-01-2016 09:53 PM


    Thread Tools Search this Thread
    Search this Thread:

    Click for Advanced Search

    Posting Rules
    You may not post new threads
    You may not post replies
    You may not post attachments
    You may not edit your posts

    BB code is On
    Smilies are On
    [IMG] code is On
    HTML code is Off
    Trackbacks are Off
    Pingbacks are Off
    Refbacks are Off

    Forum Jump

    Sponsored Ads
    Vendor Directory

    All times are GMT -4. The time now is 03:25 AM.


    We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
     
    • Ask a Question
      Get answers from community experts
    Question Title:
    Description:
    Your question will be posted in: