Wont go in key fob programation
06-12-2018, 07:04 PM
#1
1st Gear
Thread Starter
Member Since: Jun 2018
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Wont go in key fob programation
Heelo, tried to program a second key fob bu 2009 Corvette wont recognise 5 key turn in the trunk switch. Did anybody have the samve trouble? Thanks. Dominic
06-12-2018, 07:36 PM
#2
Race Director
Member Since: Jul 2007
Location: Arlington Hts, IL
Posts: 15,905
Received 1,090 Likes
on
797 Posts
St. Jude Donor '13-'14-'15-'16-'17-'18-'19-'20-'21-'22-'23-'24
Great 1st post!! Everybody finds us when they have a problem!! 
There are plenty of threads on the subject. The word you created sometimes doesn't work.
I had mine done with a Tech 2.
There are plenty of threads on the subject. The word you created sometimes doesn't work.
I had mine done with a Tech 2.
06-12-2018, 08:01 PM
#3
Intermediate
I had the same problem. Ended up finding the wire connection plug in the trunk. Disconnected then touched a jumper to the plug 5 times. The DIC went into program mode
06-13-2018, 10:27 AM
#5
Drifting
Member Since: Sep 2014
Location: Atlanta - - - - - Save the manuals
Posts: 1,924
Received 387 Likes
on
321 Posts
- I had not used the key in forever, a small shot of lub and several good twists (don't break the key obviously ) fixed that.
- I believe that you must do the 5 turns contacting the stop within 5 seconds. This can be a bit difficult ... See number one.
Last edited by Dutch08; 06-13-2018 at 10:28 AM.
06-13-2018, 12:30 PM
#6
would not allow programming
a few shots of lube in key slot and a bunch of turning finally
allowed programming mode to work
good luck