C6 Z06 Fender Vents
06-13-2018, 09:02 PM
#1
Cruising
Thread Starter
Member Since: Nov 2016
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
C6 Z06 Fender Vents
Wondering how to remove the fender vent scoops on a c6 z06?
Most concerned about the front fenders and wondering if the process is the same for the rears?
Thank you in advance!
Most concerned about the front fenders and wondering if the process is the same for the rears?
Thank you in advance!
06-13-2018, 09:23 PM
#2
Race Director
Pro Mechanic
Member Since: Apr 2014
Location: Washington Township Michigan
Posts: 14,521
Received 3,951 Likes
on
2,470 Posts
2024 Corvette of the Year Finalist - Unmodified
2023 C6 of the Year Winner - Unmodified
2020 C6 of the Year Finalist - Unmodified
2019 C6 of Year Finalist (appearance mods)
Process for Fronts...………..
Raise and support vehicle.
Remove the front wheel and tire.
Remove the rear portion of the front wheelhouse liner.
Remove the fender ornament from the inside of the wheelhouse opening by releasing the three integral tabs on the inboard side of the front fender ornament.
Similar for rears, although there also will be some "noise insulation" material to remove from both the fronts and rears as well (packed in a plastic bag)
Raise and support vehicle.
Remove the front wheel and tire.
Remove the rear portion of the front wheelhouse liner.
Remove the fender ornament from the inside of the wheelhouse opening by releasing the three integral tabs on the inboard side of the front fender ornament.
Similar for rears, although there also will be some "noise insulation" material to remove from both the fronts and rears as well (packed in a plastic bag)
