Just bought a GM full length spoiler. Need template and instructions...
#1
Instructor
Thread Starter
Just bought a GM full length spoiler. Need template and instructions...
Does anyone have an old instructions and template that they may have saved from their install that they'd be willing to mail me?
I could probably guestimate the placement, but the template would probably help.
I'll send them right back to you if you'd like.
Thanks for any and all help !
I could probably guestimate the placement, but the template would probably help.
I'll send them right back to you if you'd like.
Thanks for any and all help !
Last edited by jjbravo1; 07-14-2018 at 10:19 PM.
The following users liked this post:
jjbravo1 (07-14-2018)
#4
Instructor
Thread Starter
It's a matter of swapping the studs, installing the Timmermans, then dropping the studs into the existing center holes to get the outsides marked to drill where the Timmermans make contact.
I thought so, but the template would be much handier...
#5
Instructor
Thread Starter
I'm on it.
Thank you !
#6
Race Director
I simply lightly taped paper over the holes in(leave enough sticking out to tape to car) bottom of spoiler and poked a hole thru the locations. Then covered the the car with blue painters tape to prevent scratches, place spoiler in position, then tape paper to car, then lift off spoiler ( make sure it was lightly taped so spoiler will lift without pulling paper off car. Now drill your holes!
#7
Melting Slicks
Member Since: Apr 2018
Location: Auburn,WA (30 miles SE of Seattle) WA
Posts: 3,282
Received 936 Likes
on
600 Posts
2023 C6 of the Year Finalist - Modified
2022 C6 of the Year Finalist - Modified
Please allow me to bump this thread by adding......................
I have New In Box (shipping Included) ZR-1 C6 Spoiler
painted Inferno Orange
Reproduction by RPI Designs
$299 PAYPAL
I have New In Box (shipping Included) ZR-1 C6 Spoiler
painted Inferno Orange
Reproduction by RPI Designs
$299 PAYPAL