Just wrapped halo!
#21
Instructor
Thread Starter
For my first attempt I had ordered a 12" x 96" piece, however a 12" x 84" piece would have been sufficient for the halo. I messed up my first one, so I ordered a 24" x 96" piece just in case I messed up again. But I was able to get it done on the second attempt. So I have some left over. I might wrap something else later. I'm not going to worry about wrapping my solid top because I think I will use my glass top all the time.
#22
Advanced
For my first attempt I had ordered a 12" x 96" piece, however a 12" x 84" piece would have been sufficient for the halo. I messed up my first one, so I ordered a 24" x 96" piece just in case I messed up again. But I was able to get it done on the second attempt. So I have some left over. I might wrap something else later. I'm not going to worry about wrapping my solid top because I think I will use my glass top all the time.
The following users liked this post:
davyboy39 (01-21-2019)
#23
Instructor
Thread Starter
The following users liked this post:
Pete Schweaty (01-21-2019)
The following users liked this post:
davyboy39 (01-21-2019)
The following users liked this post:
davyboy39 (01-21-2019)
The following users liked this post:
davyboy39 (01-21-2019)
#28
Looking good!! Where did you source your 3M?
The following users liked this post:
davyboy39 (01-21-2019)
#29
Melting Slicks
#30