[ZR1] 09 ZR1 @ Dasilvamotorsports - Lingenfelter Pulley install
#1
Former Vendor
Thread Starter
Member Since: Jun 2012
Location: Breslau Ontario
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
09 ZR1 @ Dasilvamotorsports - Lingenfelter Pulley install
Paul's 09 ZR1 / We installed a Lingenfelter pulley and did a little tune
We started at 550 RWHP went to 587 and with a few more tweek's we are at :
624RWHP and 595 TQ @ 13.5PSI
This is just a sample video and not the final numbers we got .
We started at 550 RWHP went to 587 and with a few more tweek's we are at :
624RWHP and 595 TQ @ 13.5PSI
This is just a sample video and not the final numbers we got .
Last edited by Dasilvamotorsports; 08-16-2012 at 11:54 AM.
#3
Former Vendor
Thread Starter
Member Since: Jun 2012
Location: Breslau Ontario
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
#4
Melting Slicks
Very nice...Did you leave the factory TB, snout, air intake? Assuming it was the upper pulley, not lower, based on 10PSI.
#5
Former Vendor
Thread Starter
Member Since: Jun 2012
Location: Breslau Ontario
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
#6
Melting Slicks
Bring it to BC so we can see it
#7
#8
Former Vendor
Thread Starter
Member Since: Jun 2012
Location: Breslau Ontario
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
We have the experinece and know how , bring it over
#11
Melting Slicks
#13
Former Vendor
Thread Starter
Member Since: Jun 2012
Location: Breslau Ontario
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
#14
Now this is what I've been looking for in Canada...where is Breslau located in Ontario ?
I'm interested in doing these mods to my ZR1
I'm interested in doing these mods to my ZR1
#15
Former Vendor
Thread Starter
Member Since: Jun 2012
Location: Breslau Ontario
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
We are 1 hour west of Toronto
1 hour east of London and 45 mins from Hamilton
#18
Le Mans Master
#20
Le Mans Master
I didn't notice that. I am not sure if the 587 is tune and then pulley or vice versa. I do know that at 13.5 psi the bypass valve will open and dump the boost so if it is just pulley then it probably is still dumping boost. Thats no bueno.