[Z06] LG long tube headers vibration
#1
Intermediate
Thread Starter
Member Since: May 2011
Location: Jacksonville Florida
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
LG long tube headers vibration
I installed new LG long tubes headers with cats and X pipe in my 2010 ZO6, now the passenger header is vibrating agains the frame. I looked and everything looks ok and tied. The driver side don't touch anywhere. By the way the installation was done by a high performance shop and they dyno it after they finished. Need help, thanks.
#2
Drifting
Member Since: Feb 2006
Location: Cocoa Florida
Posts: 1,890
Likes: 0
Received 0 Likes
on
0 Posts
I had all sorts of problems with mine... the order you tighten the bolts seems to matter. I know that doesn't really help since a shop did it, but i'd bring it back to them and ask them to refit it.
took my 3 times with my kooks before things fit decently.
took my 3 times with my kooks before things fit decently.
#4
Race Director
With the motor hot, place a tire iron between the header and the frame. Give it a gentle pry. You'll get your 1/8" and will be fine.
#5
Race Director
If you cannot get the added clearance by having the shop check the bolts, then a little dent in the offending primary is the best solution.