lucxy

So finally my mod itch got to me and I decided to spice up my z06 a bit.
Baseline (466 whp SAE, Mustang dyno):
Halltech MF103, Corsa X pipe, Corsa Exhaust,
Diablew tune (Custom tune by Lew)

Added ARH headers, 160 deg thermostat and dyno tune with HP tuners.
Final: 478 whp SAE, Mustang dyno.

All the work was done at JTM Motor in Huntigton NY.

Ia m not sure what the conversation factor is from mustang dyno to dynojet, but my understanding is that dynojet reads higher about 7%, but I might be wrong.
Here are the 2 videos of the final 2 pulls with ARH headers:

Let me know what you think. Are these expected numbers?

kumar75150

You results look similar to my last z06. It dynoed 469whp stock, which is really high.

But after CAI and headers, it dynoed 484whp which is in line with what Ive seen from other cars with similar mods.

lucxy

Well 466 was not stock. The baseline is with some mods including diablew tune. Also keep in mind that mustang dyno reads lower than dynojet. I think your numbers are dynoject numbers. Correct?

propain

Nice job! Ready for a rematch?

lucxy

hehe, could not wait to keep it stock for long.
Still have your red z06? Any work done to it?

propain

Still have it. Still stock at the moment. Warranty expired. On the fence lately about selling as I got a good offer from someone.....

but pretty much about to drop it off for some mods.

Heads, Intake, Headers, Cam, Tune.

570-580whp when I'm done I hope depending on the cam. Unless I do the Supercharger then i'll be north of 600whp.

So if you wanna race and beat me now would be the time.

lucxy

Very nice. I am thinking about doing heads as well.