When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
[ZR1] C7 competition seats in a C6 Corvette ZR1 conversion finished
C6 Corvette ZR1 & Z06General info about GM’s Corvette Supercar, LS9 Corvette Technical Info, Performance Upgrades, Suspension Setup for Street or Track
Finally got the passanger seat finished. Fully functioning C7 Corvette competition seats except for airbags, they have been removed. I will start on the driver side this weekend. But I am extremely happy with the results of the passenger side.
C7 competition seats in a C6 Corvette.
These seats look amazing.. Is your airbag light on or were you able to reprogram the module to ignore the seats? Did you end up cutting the harness on the car or the seats to make this work? I'm not too far from you if you'd be willing to assist in the wiring for $, granted I can find Comp seats.
The cooling feature is only fans that circulate in the seat. They are wired to a "key on" fuse and I wired a one speed toggle and put it next to the seat adjusters.
These seats did not come with heaters or the cooling fan. I had to order the C7 comp seat heaters and fans for these seats. You will have to use the thermostatic leads from the C6 heaters and wire them in the c7 heat pads (this is required to make the heaters kick on in the C6). After that...simply use the C6 logic box for the seat heaters and this will allow you to use the stock "heated seat" button on the console to control them.
Did the fans have any info on them? like RPM or flow rate? Where they the same thickness of the foam? Do they blow air up or suck air down? Finally do they have 4 holes in the corners like a typical pc fan? Thanks!!
How much are these seats new? I contacted one of the site vendors and was given an estimate of about $10,000 for both seats??
Used set on eBay for $2500 for the pair...ugly color though. Would need to have them recovered, but that would not be too difficult and one could make them customized to their C6.
I noticed that in a review video they did of dissecting it. I was going to try and see if i could find that material to lay over the foam before the cover went back on.
I am in the final stages of installing my c7 seats into my c6; the electronics have been figured out....and it actually was pretty easy to do...i have one other added feature that i have incorporated into my seats that allow me to use the fans...everything works...yaahoo great....!!!!
04-11-2016, 08:57 PM
