[Z06] Anyone powder coat the OEM fuel rail?
#1
Safety Car
Thread Starter
Anyone powder coat the OEM fuel rail?
I'm going back to the OEM fuel rail when I install the MSD intake... Was planning to just paint it black to match the intake, but now I'm thinking about having it powder coated. I really don't know much about powder coating.. I'm betting someone else here has already done this??
#2
Pro
I'm going back to the OEM fuel rail when I install the MSD intake... Was planning to just paint it black to match the intake, but now I'm thinking about having it powder coated. I really don't know much about powder coating.. I'm betting someone else here has already done this??
Yes Sir I have Powder coated (2) of them and going to powder coat another satin black to compliment my Mamo Ported/Painted MSD intake. Cost you about $50
#3
Safety Car
Thread Starter
Great!
I need to find someplace to send it to....
Did you coat the quick connect fitting area? (Not sure what else to call that, but I'm sure you know what I'm referring to.....)
I need to find someplace to send it to....
Did you coat the quick connect fitting area? (Not sure what else to call that, but I'm sure you know what I'm referring to.....)
#4
Team Owner
Schrader valve...and you'd most likely want to mask the threads/end.
Edit...unless your talking about the fuel supply end. You'd want to mask that as well.
Edit...unless your talking about the fuel supply end. You'd want to mask that as well.
Last edited by MTPZ06; 02-27-2017 at 01:14 PM.
#6
Safety Car
Thread Starter
#7
Team Owner
The following users liked this post:
MTPZ06 (03-01-2017)
#15
Safety Car
Thread Starter
Not sure if my oven rack would hold the weight.... Good timing though, I'm in the middle of converting our last machine over to tilt-pads bearings, and was just inspecting the thrust pads.