[ZR1] Hood louvers/vent for zr1
The following users liked this post:
chassed (03-15-2019)
#7
Race Director
OP, there is likely some useful information in this (older) thread...
https://www.corvetteforum.com/forums...ce+hood+window
https://www.corvetteforum.com/forums...ce+hood+window
The following users liked this post:
chassed (03-15-2019)
The following users liked this post:
chassed (03-15-2019)
#9
Burning Brakes
Just be sure to move the heat gun around the window (inside of hood) where the adhesive is located. Don't hold the heat gun in one spot to long or you could damage the paint or window. You can use a flat blade screwdriver to help separate the window from the hood. The adhesive should start to release at around 350*, but it take forever at that temp .
The following users liked this post:
chassed (03-15-2019)